Instructions / Assembly

ManualsBrandsHome Styles ManualsDecorPrescott Student Desk and Hutch in Black

88 5514 16

Desk

Student

PART LIST

HARDWARE LIST

IMPORTANT NOTE

Carefully remove all the parts from the carton and put

them individually on a soft cloth to prevent scratches

or other damages occuring to the wood parts.

We have taken great care in the design of this

product and request that you carefully and strictly

follow our assembly instructions to ensure a

completed product as it was designed.

Top

1 pc.

Side Frame

1 pc.

Side Frame

1 pc.

Front Frame

1 pc.

Divider

1 pc.

Stretcher

1 pc.

Drawer

1 pc.

Drawer

1 pc.

Back Stretcher

1 pc.

(M6x35)

Head Cap Bolt

14 pcs. (+1 extra )

(M6x28)

Head Cap Bolt (short)

2 pcs. (+1 extra )

Flat Washer

16 pcs. (+1 extra )

Hex Wrench

1 pc.

Small Hex Wrench

1 pc.

Spring Washer

16 pcs. (+1 extra )

(M3x38)

Wood Screw

2 pcs. (+1 extra)

Tools required for assembly : Tools recommended for assembly :Phillips screwdriver Level

Home Styles Consumer Assistance: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319

(Please refer to the last page(s) of these instructions for drawer assembly steps.)

Summary of content (4 pages)

PAGE 1
88 5514 16 Student Desk IMPORTANT NOTE Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damages occuring to the wood parts. We have taken great care in the design of this product and request that you carefully and strictly follow our assembly instructions to ensure a completed product as it was designed. PART LIST A. Top 1 pc. B. Back Stretcher 1 pc. C. Divider 1 pc. D. Front Frame 1 pc. G. Stretcher 1 pc. E. Side Frame 1 pc. I.
PAGE 2
Assembly Instructions 2/4 IMPORTANT * Do not tighten up all the bolts and screws until each part is properly assembled. * You should keep Hex Wrench in a safe place as you may need to tighten up the Bolts in the future. * Use a soft cloth between these parts and the floor. * After assembly, item must be level to work properly. Use the included adjustable levelers to level.
PAGE 3
Assembly Instructions 3/4 H I STEP 3 Turn the unit over to its’ upright position. Slide Drawers (H) and (I) into position. To level the unit, adjust the adjustable levelers on the bottom of unit. (See Figure 2) Note: Unit must be level to work properly.
PAGE 4
Assembly Instructions 4/4 Drawer (H) H H4 Figure 4 Figure 3 H1 H3 H2 H4 STEP 1 Attach H2 to H3 and H4, then flip the Locks. (See Figures 3 and 4) H5 H3 H2 STEP 2 Slide H5 into the grooves in H3 and H4. Be sure to push H5 all the way forward so it meets H2. Drawer (I) Attach H1 to unit, then flip the Locks. I H4 I1 H2 H4 H3 STEP 1 H5 H2 Attach H2 to H3 and H4, then flip the Locks. (See Figures 3 and 4) H3 STEP 2 Slide H5 into the grooves in H3 and H4.