Instructions / Assembly

Part List

IMPORTANT NOTE

Carefully remove all the parts from the carton and put

them individually on a soft cloth to prevent scratches

or other damages occuring to the parts.

We have taken great care in the design of this

product and request that you carefully and strictly

follow our assembly instructions to ensure a

completed product as it was designed.

Hardware List

Key Wrench

1 pc.

Top

1 pc.

Support

1 pc.

Support

1 pc.

Small

Hex Wrench

1 pc.

M8x40

Head Cap Bolt

8 pcs.(+1 extra)

M6x40

Head Cap Bolt

(long)

4 pcs.(+1 extra)

Flat Washer

4 pcs.(+1 extra)

M6x20

Head Cap Bolt

(short)

1 pc. (+1 extra)

Base

1 pc.

Base

1 pc.

Leg

4 pcs.

Dining Table

88 5601 32

Home Styles Consumer Assistance: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319

Tools recommended for assembly : Level

PAGE 1
88 5601 32 Dining Table IMPORTANT NOTE Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damages occuring to the parts. We have taken great care in the design of this product and request that you carefully and strictly follow our assembly instructions to ensure a completed product as it was designed. Part List A. Top 1 pc. B. Support 1 pc. D. Leg 4 pcs. C. Support 1 pc. F. Base 1 pc. E. Base 1 pc. Hardware List Key Wrench 1 pc.
PAGE 2
Assembly Instructions 2/3 IMPORTANT * Do not tighten up all the screws until each part is properly assembled. * You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future. * Use a soft cloth between these parts and the floor. * After assembly, item must be level to work properly. Use the included adjustable levelers to level. STEP 1 Attach Base (E) to Base (F) with Head Cap Bolt (short).
PAGE 3
Assembly Instructions 3/3 Head Cap Bolt B STEP 3 Turn unit to its’ upright position. C Attach Supports (C) and (B) to unit with Head Cap Bolts. STEP 4 Place Top (A) upside down on a soft cloth. Attach unit to Top (A) with Head Cap Bolts (long) and Flat Washers. Head Cap Bolt (long) Flat Washer Turn the table over to its’ upright position. A To level the table, adjust the adjustable levelers on the bottom of legs. (See Figure 2) Figure 2 Note: Frozen precipitation may damage the top.