Installation Guide

ManualsBrandsHome Styles ManualsBathBold W-13, D-11, H-28 Stainless Steel 3 Tier Bath Shelf Space Saver

Top

1 pc.

Side Frame

2 pcs.

Shelf

1 pc.

Base

1 pc.

Hardware List

Part List

20 05617 0103

IMPORTANT

Home Styles Customer Service: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com,

888-680-7460, 877-831-0319

Carefully remove all the parts from the carton and

place them individually on a soft cloth to prevent

scratches or other damage.

Carefully and strictly follow these assembly instructions

to ensure a completed product as designed.

Do not use power tools above 8 volts to assemble.

Three Tier Shelf

Hex Wrench

1 pc.

Small Hex Wrench

1 pc.

M6x10

Head Cap Bolt

20 pcs. (+1 extra)

Spring Washer

20 pcs. (+1 extra)

Tool(s) required for assembly: Level

Summary of content (4 pages)

PAGE 1
20 05617 0103 Three Tier Shelf IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble. Part List A. Top 1 pc. C. Shelf 1 pc. B. Side Frame 2 pcs. D. Base 1 pc. Hardware List Hex Wrench 1 pc. Small Hex Wrench 1 pc. M6x10 Head Cap Bolt 20 pcs.
PAGE 2
Assembly Instructions 2/3 IMPORTANT Use a soft cloth between these parts and the floor. Do not use power tools above 8 volts to assemble. Do not tighten all the bolts until each part is properly assembled. The unit must be level to work properly. Use the included adjustable levelers to level. Keep Hex Wrench as the bolts may need to be tightened in the future. STEP 1 Attach Shelves (C) and Base (D) to Side Frame (B) with Spring Washers and Head Cap Bolts, tightening bolts only halfway.
PAGE 3
Assembly Instructions 3/3 STEP 3 Place Top (A) upside down on a soft cloth. Attach unit to Top (A) with Spring Washers and Head Cap Bolts, tightening bolts only halfway. (See Figure 2) Tighten all Head Cap Bolts used in all steps. Figure 2 Spring Washer A STEP 4 Turn unit over to its’ upright position. Level unit by adjusting the adjustable levelers on bottom of unit.
PAGE 4
CARE INSTRUCTIONS NEVER NEVER use glass cleaners on finished furniture. Ammonia chemically attacks the finish. allow liquids to remain on furniture. Absorption causes parts to warp and split and finishes to delaminate. Do not use power tools above 8 volts to assemble. Do not place in direct sunlight. Do not write directly on surface. PREVENT CRACKING PREVENT FADING PREVENT MARKING Do not place hot objects on surface. Do not use rubber based placemats. Do not use commercial waxes and polishes.