User's Manual

(/,

0,1$

Connect the Data Jack

1. With your computer turned off, connect the female end of the Data Jack

cable to an available 9-pin serial port on the computer.

2. Connect the male end of the cable to the Data Jack.

3. Plug the Data Jack into a standard 110v electrical outlet.

4. Turn on your computer.

Run the Installation Wizard

1. If Windows isn’t running on your PC, start it now.

2. Insert the driver diskette included with the Data Jack into your PC’s floppy

disk drive.

Note: The Data Jack driver software is provided on a 3-1/2” diskette. If you

need a different medium, contact HWN Customer Service at 1-888-WHY-

WIRE.

3. Click the Start button on the Taskbar.

4. Click Run.

5. In the Run dialog box, click the down arrow to the right of the “Open” field.

6. Click “a:\setup” or “b:\setup” (whichever is appropriate).

7. Click OK.

8. Follow the on-screen prompts to complete the installation.