Installation & Assembly

Solar Path Light (4-Pack)

Model No. ELJ7012V

(888) 782-5618

IMPORTANT SAFETY OPERATING INSTRUCTIONS

1. Please read all warning and instruction labels which are included in the box and ﬁxture to avoid personal injury, property damage

caused by ﬁre, cuts, bruises, death and other dangers.

2. Please follow these general precautions before installing, maintaining, or ﬁxing

1. It is important to select an outdoor location with full, direct sunlight where the solar panel can receive at least 8 hours of sunlight

each day.

2. It is important to avoid placing the solar light by light sources, such as street lights or porch lights, which may cause the solar light

to turn off automatically.

3. To avoid explosion and corrosion, please keep the solar light away from ﬁre and humid environment

4. No striking to avoid any damages to solar cell

1. The packing contains small parts that could be swallowed by children

2. Keep the packaging material away from children and pets

3. The solar light is not a toy

4. We do not take responsibility if the instruction manual is not followed correctly or if the product is handled

improperly resulting in damage to person or property

PRECAUTION

1. Dimension: approx. W.5.5" (13.97cm) x D.5.5" (13.97cm) x H.20" (50.8cm )

2. Light source: 1pc white LEDs

3. Brightness: 6lumens

REF. PARTS

PARAMETER:

Solar Unit

sec urit y

www.homezonesecurity.com

PAGE 1
Solar Path Light (4-Pack) Model No. ELJ7012V s ecu ri ty IMPORTANT SAFETY OPERATING INSTRUCTIONS 1. Please read all warning and instruction labels which are included in the box and fixture to avoid personal injury, property damage caused by fire, cuts, bruises, death and other dangers. 2. Please follow these general precautions before installing, maintaining, or fixing 1. The packing contains small parts that could be swallowed by children 2. Keep the packaging material away from children and pets 3.
PAGE 2
Solar Path Light (4-Pack) Model No. ELJ7012V s e cu ri ty HOW TO OPERATE AND INSTALL Figure 1 • Twist the Glass Lens (Part B) and remove it from the Solar Panel Unit (Part A). • Slide the switch which is on the bottom of the Solar Panel Unit (Part A ) to "ON" position • Replace the Glass Lens (Part B) accordingly. Figure 2 • Insert the Tube (Part C) to the Glass Lens (Part B), and then the Ground Spike (Part D).