Installation Guide
2
www.homewerksww.com
PRODUCT SPECIFICATIONS
SPECIFICATIONS SPECIFICATIONS
Max. Flow Rate: 1.2 GPM (4.54 LPM) at 60 PSI Ceramic cartridges
ASME A112.18.1/CSA B125
Manufactured to include no more than 0.25% weighted average lead content
on wetted surfaces
NSF 61-9
Polished chrome, brushed nickel or oil rubbed bronze nish
Weight: 3.743 lbs.
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
1
5.
Preparing Pop-up
Assembly:
Remove the preassembled stop-
per (1) and ange (2) from the
pop-up assembly (3). Screw the
nut (4) all the way down the pop-
up assembly (3). Push the gasket
(5) down on top of the pop-up
assembly (3) to rest on top of the
nut (4).
1
2
3
4
5
5
2. Position the washer (1) and bonnet
(2) on top of the cartridge (3) and
twist the bonnet (2) to secure it to
the top of the bonnet (2). Insert the
cartridge (3) and bonnet (2) into the
handle (4) untile the assembly is tight
and secure inside the handle (4).
Place the handle (4) on the faucet
body (5) with the handle facing away
from the faucet body (5), and snap
into place. Repeat steps for the other
handle.
1
2
3
4
5
2
6.
Installing Pop-up
Assembly:
Apply silicone sealant to the
underside of the ange (1). Apply
sealant tape to the threads at the
fop of the pop-up assembly (2).
Insert the pop-up assembly (2)
into the sink. Screw the ange (1)
onto the pop-up assembly (2).
Ensure the pivot hole faces the back
of the sink. Tighten the nut (3) and
gasket (4). Do not overtighten.
Clean off any excess sealant.
Remove the pivot nut (5).
1
2
3
4
5
6
3. Place the base plate (1) on the
bottom of the faucet (2). Place the
faucet (2) through the mounting
holes on the sink. Attach the faucet
(2) to the sink by securing the
mounting nuts (3) on the threaded
ends of the faucet (2) underneath
the sink.
1
2
3
3
7.
Installing the Stopper:
Insert the stopper (1) into the
sink. Remove the preassembled
horizontal rod (2) and clip (3)
from the lift rod strap (4). Install
the horizontal rod (2) into the
pop-up assembly (5) and through
the hole of the stopper (1). Install
the pivot nut (6) onto the hori-
zontal rod (2) and hand tighten
back onto the pop-up assembly
(5). Re-attach the lift rod strap (4)
to the horizontal rod (2) using the
clip (3).
1
4
2
3
5
6
7
4.
Connecting Water Supply
Lines:
Make connections to the water
supply lines. Use 1/2 in. IPS faucet
connections or use coupling nuts
with 3/8 in OD ball-nose risers. Use
wrenches to tighten the connec-
tions. Do no overtighten.
4
8.
Installing the Lift Rod:
Insert the lift rod (1) through the
faucet body (2) and into the strap
(3). Tighten the screw (4).
1
1
2
3
4
8