Blower/Vac Operator's Manual

Page 9
ASSEMBLY
WARNING:
Stop the engine and disconnect the spark plug wire
before installing parts, making adjustments, cleaning, or
when not in use. Failure to do so could result in possible
serious personal injury.
INSTALLING THE BLOWER TUBE
See Figure 2.

Align the raised tabs on the main blower housing to the slots
on blower tube; slide together and rotate tube clockwise
to secure.

To remove, rotate the blower tube counterclockwise to
release.
INSTALLING THE HANDLE
See Figure 3.

Place unit on a flat level surface.

Insert handle into the hole on the base of the blower until
the handle is fully seated.

Insert handle knob and rotate clockwise to secure.
INSTALLING THE VACUUM BAG
See Figure 4.

Rotate the blower tube counterclockwise and remove.

Place the neck of the vacuum bag over the blower housing
outlet until the drawstring area rests between the raised
ribs.

Squeeze the sides of the fastener with one hand while
drawing the string tightly with the other until the bag is
securely attached.

Rotate the vacuum bag until the shoulder strap is upright.

Make sure the vacuum bag is zipped and closed before
starting the unit.
Fig. 2
Fig. 3
bloweR Tube
bloweR
houSinG
Fig. 4
handle
handle
knob
hole
vacuum
baG
dRawSTRinG
RaiSed
RibS
faSTeneR
ShouldeR
STRaP