Trimmer User Manual

Page 12
OPERATION
Fig. 9
proper operating
position
WARNING:
Always hold the string trimmer away from your body, keep-
ing clearance between your body and the product. Any
contact with the housing or string trimmer cutting head can
result in burns and/or other serious personal injury.
CUTTING TIPS
See Figures 9 - 10.
 Avoid hot surfaces by always keeping the tool away from
your body. (Proper operating position shown in figure 9.)
Keep the trimmer tilted toward the area being cut; this is
the best cutting area.
The curved shaft trimmer cuts when passing the unit from
right to left. The straight shaft trimmer cuts when passing
the unit from left to right. This will avoid throwing debris at
the operator. Avoid cutting in the dangerous area shown
in figure 10.
 Use the tip of string to do the cutting; do not force string
head into uncut grass.
 Wire and picket fences cause extra string wear, even
breakage. Stone and brick walls, curbs, and wood may
wear string rapidly.
 Avoid trees and shrubs. Tree bark, wood moldings, siding,
and fence posts can easily be damaged by the string.
ADVANCING STRING USING THE EZ WIND
™
TAP ADVANCE SYSTEM
String advance is controlled by tapping string head on grass
while running engine at full throttle.
 Run engine at full throttle.
 Tap string head on ground to advance string. String
advances each time the head is tapped.
 Several taps may be required until string strikes the cut
off blade.
 Resume trimming.
NOTE: If the string is worn too short you may not be able to
advance the string by tapping it on the ground. If so, STOP
THE ENGINE, and manually advance the string.
ADVANCING THE STRING MANUALLY
With the engine off, push the spool retainer down while pull-
ing on string(s) to manually advance the string.
CUT-OFF BLADE
This trimmer is equipped with a cut-off blade on the grass
deflector. For best cutting, advance string by tapping the
string head until the string is trimmed to length by the cut-off
blade. Advance string whenever you hear the engine running
faster than normal, or when trimming efficiency diminishes.
This will maintain best performance and keep string long
enough to advance properly.
dangerous
cutting area
best cutting area
best cutting area
dangerous
cutting area
mightylite 26ss
direction
of
rotation
mightylite 26cs
Fig. 10
direction of
rotation