OPERATOR’S MANUAL ELECTRIC LAWN MOWER 18 in. – UT13118 20 in. – UT13120 Your lawn mower has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product. Thank you for your purchase.
TABLE OF CONTENTS Introduction ...................................................................................................................................................................... 2 General Safety Rules .....................................................................................................................................................3-4 Specific Safety Rules ..............................................................................................................
GENERAL SAFETY RULES Use the right appliance. Do not use the lawn mower for any job except that for which it is intended. WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below and on the machine may result in electric shock, fire, and/or serious personal injury. READ ALL INSTRUCTIONS This cutting machine is capable of amputating hands and feet and throwing objects. Failure to observe all safety instructions could result in serious injury or death.
GENERAL SAFETY RULES Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit(s) or outlet(s) to be used for the lawn mower. Receptacles are available having builtin GFCI protection and may be used for this measure of safety. Inspect extension cords periodically and replace if damaged. Keep handles dry, clean, and free from oil or grease.
SYMBOLS Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the product better and safer. SYMBOL NAME DESIGNATION/EXPLANATION V Volts Voltage A Amperes Current Hz Hertz Frequency (cycles per second) W Watt Power hrs Hours Time Class II Construction Double-insulated construction Wet Conditions Alert Do not expose to rain or use in damp locations.
SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING DANGER: Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
ELECTRICAL DOUBLE INSULATION Double insulation is a concept in safety in electric power tools, which eliminates the need for the usual threewire grounded power cord. All exposed metal parts are isolated from the internal metal motor components with protecting insulation. Double insulated tools do not need to be grounded. It is possible to tie the extension cord and power cord in a knot to prevent them from becoming disconnected during use.
FEATURES PRODUCT SPECIFICATIONS UT13118 Input ................................. 120 V, 60 Hz, AC only, 12 Amps No-load Speed ...................................... 3,600 r/min. (RPM) Cutting Path ............................................................... 18 in. Height Adjustments ............................. 1-3/4 in. to 3-3/4 in. Wheel Size .................................................................... 7 in. Weight .......................................................................
FEATURES KNOW YOUR LAWN MOWER MOTOR/BLADE CONTROL ASSEMBLY See Figure 2. The safe use of this product requires an understanding of the information on the product and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. Your mower is equipped with a mulching plug that cuts and recuts the grass for finer clippings.
ASSEMBLY HANDLE KNOBS WARNING: Never operate the mower without the proper safety devices in place and working. Never operate the mower with damaged safety devices. Failure to heed this warning can result in serious personal injury. UPPER HANDLE ADJUSTING HANDLE LOWER HANDLE See Figure 3. Fully loosen the handle knobs on both sides of the handle. Pull up and back on the upper handle to raise the handle into operating position. Make certain the handles snap into place securely.
ASSEMBLY INSTALLING THE GRASS CATCHER (MODEL UT13120 ONLY) See Figure 6. NOTE: When using the grass catcher, do not install either the side discharge deflector or the mulching plug. MODEL UT13120 ONLY Lift the rear discharge door. Lift the grass catcher by its handle and place under the rear discharge door so that the hooks on the grass catcher are seated on the door rod. Release the rear discharge door.
OPERATION WARNING: Do not allow familiarity with this type of product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. MOWER PLUG CORD RETAINER WARNING: Always wear safety goggles or safety glasses with side shields when operating this product. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
OPERATION For a healthy lawn, always cut off one-third or less of the total length of the grass. � When cutting heavy grass, reduce walking speed to allow for more effective cutting and a proper discharge of the clippings. Do not cut wet grass. It will stick to the underside of the deck and prevent proper mulching of grass clippings. New or thick grass may require a narrower cut.
MAINTENANCE WARNING: WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use.
MAINTENANCE Place the new blade on the shaft against the fan assembly. Make sure it is installed with the curved ends pointing up toward the mower deck and not down toward the ground. FAN ASSEMBLY Replace the blade insulator and spacer, then thread the blade nut on the shaft and finger tighten. NOTE: Make certain all parts are replaced in the exact order in which they were removed. SHAFT Torque the blade nut down using a torque wrench (not provided) to ensure the bolt is properly tightened.
MAINTENANCE REPLACING WHEELS See Figure 16. To replace a wheel: HUBCAP Disconnect the mower from the power supply. COTTER PIN � Turn the mower on its side. Using a flat blade screwdriver, pry off the hubcap. Remove the cotter pin from the wheel axle, then remove the wheel. Replace with new wheel and insert new cotter pin to secure. Replace hubcap. STORING THE MOWER WHEEL See Figure 17. Disconnect the mower from the power supply.
TROUBLESHOOTING Problem Handle not in position. Possible Cause Solution Carriage bolts not seated properly. Adjust the height of the handle and make sure the carriage bolts are seated properly. Handle knobs not tightened. Tighten handle knobs. Extension cord not connected to the mower plug. Reconnect the cord and use the cord retainer to keep the cord close to the motor/blade control. Extension cord not connected to power source. Connect the extension cord to a live 120V AC, 60 HZ AC receptacle.
EXPLODED VIEW/PARTS LIST 49 MODEL UT13118 31 30 25 24 22 20 23 28 13 1 29 32 4 33 45 44 11 15 12 10 16 35 14 2 21 18 36 37 34 38 19 42 5 40 41 7 6 17 27 3 39 8 9 43 26 Key No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 Part No. 3330390 3110137-2 3110237-2 3220575 3320237 3420190 3410190 3331638 3290135 3330537-2 3340137-1 3330737-1 3330837-1 3221637 3220737 3220137-2 3330437-1 3220608 3220439 3330637 3220136 3320338 3340237 Description Qty. Key No.
EXPLODED VIEW/PARTS LIST MODEL UT13120 32 28 44 34 30 33 4 45 11 43 51 2 10 42 31 13 1 36 52 35 29 37 5 7 38 24 25 27 14 9 48 16 17 12 15 8 19 20 22 40 6 18 3 21 49 47 46 26 39 41 Key No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 Part No.
WARRANTY LIMITED WARRANTY FOR CORDED ELECTRIC MODELS. This product is manufactured for the Great States Corporation lawn mower company under license from Homelite Consumer Products, Inc.
NOTES Page 21
OPERATOR’S MANUAL ELECTRIC LAWN MOWER 18 in. – UT13118 20 in. – UT13120 SERVICE For parts or service, contact your nearest Homelite authorized service dealer. Be sure to provide all relevant information when you call or visit. For the location of the authorized service dealer nearest you, please call 1-866-457-5888 or visit us online at www.homelite.com. REPAIR PARTS The model number of this tool is found on a plate or label attached to the housing.