OPERATOR’S MANUAL 20 in. 24 VOLT CORDLESS LAWN MOWER UT13122 Your lawn mower has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product. Thank you for your purchase.
TABLE OF CONTENTS Introduction ...................................................................................................................................................................... 2 General Safety Rules ........................................................................................................................................................ 3 Specific Safety Rules ............................................................................................................
GENERAL SAFETY RULES WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below and on the machine may result in electric shock, fire, and/or serious personal injury. READ ALL INSTRUCTIONS This cutting machine is capable of amputating hands and feet and throwing objects. Failure to observe all safety instructions could result in serious injury or death. Do not use the lawn mower in damp or wet conditions or operate in the rain.
SPECIFIC SAFETY RULES If the lawn mower strikes a foreign object, follow these steps: • Stop the lawn mower and release the switch control lever. • Disconnect the power cord. • Thoroughly inspect the mower for any damage. • Repair any damage before restarting and continuing to operate the mower. Stop the motor, remove the switch key, and wait until the blade comes to a complete stop before removing the grass catcher or unclogging the chute.
SYMBOLS Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the product better and safer. SYMBOL NAME DESIGNATION/EXPLANATION Volts Voltage A Amperes Current Hz Hertz Frequency (cycles per second) W Watt Power hrs Hours Time gal Gallon Volume qt Quart Volume Wet Conditions Alert Do not expose to rain or use in damp locations.
SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING DANGER: Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
FEATURES PRODUCT SPECIFICATIONS Battery ..................24volt, 17A/Hr sealed maintenance free No-load Speed ...................................... 3,600 r/min. (RPM) Cutting Path ............................................................... 20 in. Height Adjustments ............................. 1-1/2 in. to 3-3/4 in. Wheel Size ............................................7 in. front, 8 in. rear Weight ........................................................................ 87 lb.
FEATURES KNOW YOUR LAWN MOWER See Figure 1. The safe use of this product requires an understanding of the information on the product and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. MOTOR/BLADE CONTROL ASSEMBLY The motor/blade control, located on the upper handle of the mower, engages and disengages the motor and blade.
ASSEMBLY WARNING: HANDLE KNOBS Never operate the mower without the proper safety devices in place and working. Never operate the mower with damaged safety devices. Failure to heed this warning can result in serious personal injury. UPPER HANDLE LOWER HANDLE ADJUSTING HANDLE See Figure 2. Fully loosen the handle knobs on both sides of the handle. Pull up and back on the upper handle to raise the handle into operating position. Make certain the handles snap into place securely.
ASSEMBLY INSTALLING THE GRASS CATCHER See Figure 5. NOTE: When using the grass catcher, do not install either the side discharge deflector or the mulching plug. GRASS CATCHER HANDLE Lift the rear discharge door. Lift the grass catcher by its handle and place under the rear discharge door so that the hooks on the grass catcher are seated on the door rod. Release the rear discharge door.
OPERATION BATTERY METER See Figure 7. Since the mower battery is shipped in a low charge condition, the battery must be charged before use. The battery has 5 LED lights to indicate battery capacity. These lights will only illuminate when the mower is running. If 3 GREEN lights illuminate, the battery is charged and ready for use. 2 green lights are equal to 50-80% charge, while 1 green light is equal to 30-50% charge. LIGHT METER If the AMBER light illuminates, the battery will soon require charging.
OPERATION MOWING TIPS See Figure 10. Make sure the lawn is clear of stones, sticks, wires, and other objects that could damage the lawn mower blades or motor. Such objects could be accidentally thrown by the mower in any direction and cause serious personal injury to the operator and others. For a healthy lawn, always cut off one-third or less of the total length of the grass. � When cutting heavy grass, reduce walking speed to allow for more effective cutting and a proper discharge of the clippings.
MAINTENANCE WARNING: WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use.
MAINTENANCE Place the new blade on the shaft against the fan assembly. Make sure it is installed with the curved ends pointing up toward the mower deck and not down toward the ground. FAN ASSEMBLY Replace the blade insulator and spacer, then thread the blade nut on the shaft and finger tighten. NOTE: Make certain all parts are replaced in the exact order in which they were removed. Torque the blade nut down using a torque wrench (not provided) to ensure the bolt is properly tightened.
MAINTENANCE REPLACING WHEELS See Figure 16. To replace a wheel: HUBCAP Stop the motor and remove the switch key. � Turn the mower on its side. COTTER PIN Using a flat blade screwdriver, pry off the hubcap. Remove the cotter pin from the wheel axle, then remove the wheel. Replace with new tire and insert new cotter pin to secure. Replace hubcap. STORING THE MOWER See Figure 17. Remove the switch key and store in a secure location out of the reach of children.
TROUBLESHOOTING Problem Handle not in position. Possible Cause Solution Carriage bolts not seated properly. Adjust the height of the handle and make sure the carriage bolts are seated properly. Handle knobs not tightened. Tighten handle knobs. Battery is low in charge. Charge the battery. Battery is either defective or will not take a charge. Replace the battery. Mower cutting grass unevenly. Lawn is rough or uneven or cutting height not set properly. Move the wheels to a higher position.
EXPLODED VIEW/PARTS LIST 41 26 48 42 44 43 27 24 25 12 21 23 1 22 45 4 34 14 15 31 36 12 16 17 33 37 39 30 29 32 18 19 7 5 2 40 28 3 35 46 10 11 20 47 13 9 6 8 38 49 Key No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Part No.
WARRANTY LIMITED WARRANTY, BATTERY POWERED MODELS. This product is manufactured for the Great States Corporation lawn mower company under license from Homelite Consumer Products Inc.
NOTES Page 19
OPERATOR’S MANUAL 20 in. 24 VOLT CORDLESS LAWN MOWER UT13122 SERVICE For parts or service, contact your nearest Homelite authorized service dealer. Be sure to provide all relevant information when you call or visit. For the location of the authorized service dealer nearest you, please call 1-866-457-5888 or visit us online at www.homelite.com. REPAIR PARTS The model number of this tool is found on a plate or label attached to the housing. Please record the serial number in the space provided below.
