Trimmer User Manual

Page 9 — English
OPERATION
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.
WARNING:
Blades are sharp. When handling the blade assembly,
wear non-slip, heavy-duty protective gloves. Do not place
your hand or fingers between blades or in any position
where they could get pinched or cut. NEVER touch blades
or service unit while running.
LUBRICATING THE BLADE
See Figure 5.
For easier operation and longer blade life, lubricate blades
before and after each use. If you will be using the grass
shear for an extended period, it is advisable to oil the blade
during use.
 Stop the motor and allow blades to stop moving.
 Install padlock (not included) or lock-out pin into switch
trigger hole. Keep both hands away from switch.
Lay the grass shear on a flat surface. Apply light weight
machine oil along the edge of the top blade.
 Remove padlock or lock-out pin from switch trigger hole.
NOTE: Do not oil while the grass shear is running.
CLEANING THE GRASS SHEAR
 Stop the motor and allow blades to stop moving.
 Install padlock (not included) or lock-out pin into switch
trigger hole. Keep both hands away from switch.
Slide the sheath over the blade.
Clean dirt and debris from the body of the grass shear,
using a damp cloth with a mild detergent.
 Remove padlock or lock-out pin from switch trigger hole.
NOTE: Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by certain
aromatic oils such as pine and lemon, and by solvents
such as kerosene.
BATTERIES
This product is equipped with a nickel-cadmium recharge-
able battery. Length of service from each charging will de-
pend on the type of work you are doing.
The battery in this product has been designed to provide
maximum trouble-free life. However, like all batteries, it will
eventually wear out.
To obtain the longest possible battery life, we suggest
removing the product from the charger once it is fully
charged and ready for use.
NOTE: Batteries are not intended to be replaced.
OPERATING THE GRASS SHEAR
WARNING:
Read the safety information for safe operation using the
blade. Extreme care must be taken when using blades
to ensure safe operation. Refer to Important Safety
Instructions and Specific Safety Rules.
 Inspect and clear the area of any hidden objects.
 Never use the grass shear near power lines, fencing, posts,
buildings, or other immovable objects.
 Never use a blade after hitting a hard object without first
inspecting it for damage. Do not use if any damage is
detected.