User manual

Start-up Troubleshooting
26
27
remote control you can define the duration
under “Eco duration via wall-mount remote
control”.
Simply push the Homematic IP Wall-mount Remote
Control or slide the switch in the home screen of your
app from “Auto” to “Eco” to activate the eco mode. You
can adjust the eco duration at any time via the app.
5.4.3 Boost
With the boost function, cool rooms can be heated
within short time. You can activate the boost func-
tion via app or the device (Homematic IP Radiator or
Wall Thermostat). The radiator valve opens completely.
There will be a pleasant room temperature right away
because of the radiated heat. By the end of the boost
phase, the devices automatically change back to the
prior operating mode.
• In the app, tap on the room and then on the
boost symbol or press the control wheel of the
Homematic IP Radiator or Wall Thermostat to
activate the boost function.
• You can adjust up to six single heating and
cooling phases. Therefore, please define the
time period and the temperature for each
phase. The heating and cooling phases are dis-
played in a bar graph.
• Repeat this steps if you want to add further
heating profiles.
You can copy profiles and days with a long
press on the heating profile or single weekdays.
5.4.2 Eco mode
In the eco mode, the temperature in the house can be
reduced
• temporarily, e.g. for the weekly shopping,
• scheduled, e.g. for holidays, or
• permanently, for an undefined period of time,
in order to save energy.
• Tap on the menu symbol (H) and select the
menu item “Eco mode / Wall-mount remote
control”.
• You can define the rooms for activating the eco
mode and lowering the temperature by tapping
on “Rooms in eco mode”.
• The temperature for the eco mode can be de-
fined under “Eco temperature”.
• To activate the eco mode via the wall-mount
6 Troubleshooting
6.1 Command not confirmed
If at least one receiver does not confirm a command,
this may be caused by radio interference (see „9 Gen-
eral information about radio operation“ on page 30).
The error will be displayed in the app and may be cause
by the follow:
• Receiver cannot be reached
• Receiver is unable to execute the command
(load failure, mechanical blockade, etc.)
• Receiver is defective
6.2 Duty cycle
The duty cycle is a legally regulated limit of the trans-
mission time of devices in the 868 MHz range. The aim
of this regulation is to safeguard the operation of all
devices working in the 868 MHz range.
In the 868 MHz frequency range we use, the maximum
transmission time of any device is 1% of an hour (i.e. 36
seconds in an hour). Devices must cease transmission
when they reach the 1% limit until this time restriction
comes to an end. Homematic IP devices are designed
and produced with 100% conformity to this regulation.
During normal operation, the duty cycle is not usually
reached.
5.5 Configuration of rooms
Tap on a room in the home screen of the app and se-
lect “Configuration” to adjust the following settings:
Minimum temperature
Set the minimum temperature for this room. The tem-
perature e.g. in heating profiles or during operation of
the radiator thermostat, will not fall below the set mini-
mum value.
Maximum temperature
Set the maximum temperature for this room. The tem-
perature e.g. in heating profiles or during operation of
the radiator thermostat, will not exceed the set maxi-
mum value.
Open-window-temperature
Set the temperature that has to be maintained in this
room during ventilation.
Boost duration
Set the boost duration for this room.