Instructions

28
Start-up
Please observe the hazard information in section
“2 Hazard information” on page 22 during
installation.
Permitted cable cross sections for connecting to the
dimming compensator are:
Rigid cable [mm
2
] Flexible cable
without ferrule [mm
2
]
0.2.-1.50 0.2.-1.50
To connect or loosen the conductor, the white
actuation lever at the top of the clamp has to be
pressed.
Strip the connecting cables to a length of 8 mm
(see figure 2).
5.2 Installation
You can operate the device
• in a flush-mounted box,
• in a surface-mounted box or
• on a DIN rail
5.2.1 Installation into a flush-mounted or surface-
mounted box
The dimming compensator can be installed in a deep
flush-mounted box (switch/device box according to DIN