operation manual
40
Restore factory settings
6x long red
flashing
Device
defective
Please see your app
for error message or
contact your retailer.
1x orange
and 1 x green
lighting
Test display Once the test
display has stopped,
you can continue.
7 Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the switch actuator and
meter, please proceed as follows:
• Press and hold down the system button (A) for at
least 4 seconds using a VDE screwdriver, until the
LED quickly starts flashing orange.
• Release the system button again.
• Press and hold down the system button again for
4seconds, until the LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart.
After the restart, you can again integrate your device into
your Homematic IP system.