Operation Manual

28
Hold the drilling template supplied (see additional
sheet) at your intended mounting location and align it
vertically and/or horizontally.
When selecting a mounting location and drill-
ing in the vicinity of switches or socket outlets,
make sure that there are no cables in the wall.
• Hold the drilling template supplied (see additional
sheet) at your intended mounting location and align
it vertically and/or horizontally.
• Use a pen to mark the bore holes A and B (as
shown on the drilling template) on the wall through
the template.
• Drill the two marked holes into the wall with a diam-
eter of 5 mm. Insert the plugs in the holes. Turn the
screws into the plugs so that they protrude from the
wall by approx. 1.5 mm. Working from above/from
the right, hang the device using the brackets on the
back (J) behind the screw heads.