Operation Manual
30
7 Start-up
7.1 Simple operator functions on the device
The siren and the ashing light can be operated directly using the control
buttons and LEDs on the device (there is one control button and one
LED for each).
You can check the functions of the connected signalling device, as well
as the integrity of the electrical installation, immediately after installation
(without teaching-in).
Simply press and release the button to operate the actuator. Pres-
sing and holding down the button (for more than 4
seconds) will switch the actuator to teach-in mode.
7.2 Teaching-in
Please read this entire section before starting the teach-in procedure.
To execute the teach-in procedure, both of the devices to be connected
must be in teach-in mode and the channel to be taught-in must be
selected.
• To teach-in on an actuator channel, press and hold down the corre-
sponding channel button for approximately 4 seconds. The device
LED will ash continuously to indicate that teach-in mode is active.
Once teaching-in has been completed successfully, the device LED
will go out.
• If no teaching-in is carried out, teach-in mode will be exited
automatically after 20 seconds.
Note: If the actuator has already been taught-in on a central control unit
and is therefore blocked for direct teach-in, this will be indicated by the
device LED lighting up briey (instead of ashing continuously). Direct
teach-in is not possible.