Instruction Manual

54
Instruction Manual | BEACON40™BEACON40™ | Instruction Manual
Warm Cool
Time
1
2
3 4
White
Use the REMOTE CONTROL to set BEACON40™ to your preferences.
There is:
LOW BATTERY: Each light will ash once every ve minutes to indicate
a low battery. Remove and replace the batteries to resume use.
POWER
Turn your lights
on and o
TIME
Set your lights
to turn o
automatically
after 1, 2, 3 or
4 hours
TONE SETTING
Set your lights to warm, white
or cool. You may prefer a cooler
tone during the daytime and a
warmer light in the evenings
Insert cable
here on
BASE
Power
Supply
Power
Supply
Insert cable
here on
SATELLITE
BRIGHTNESS
Turn the knob to your desired
luminosity
BASE
LIGHT
SATELLITE
LIGHT
SETUP
1. To set up your Remote Control, remove the battery cover on the
bottom and place 4 AA batteries as indicated. Seal the battery
pack with the plastic screw using a at-head screwdriver. A blue
indicator will illuminate when it’s powered on.
2. The BEACON40™ Personal kit includes 2 lights: a BASE and
a SATELLITE. The BEACON40™ Surround kit includes 2 ad-
ditional lights.
3. Insert one power supply plug into the silver port at the back of
each light. Connect the power supplies to a wall outlet.
4. Plug the cable connector into the open OUT port in the BASE
light. Connect the other end of the cable into the IN port on the
SATELLITE light. Repeat this step for the additional lights in the
BEACON40™ Surround Kit.
5. Using the remote control, turn the power on. The lights will blink.
The blinking means that the lights are ready to pair with the re-
mote control. Hold the power button for 3-5 seconds until the
lights icker. Your remote is now paired with the lights.
IN INOUT OUT