Installation Guide

Step 1: Remove screen panels
from box and set to the side. Lay
out one panel section as shown.
Step 2: Mark bottom of screen
panel in 1-13/16” from each end.
Tip: Insert factory edge into
screen panel for easiest
installation.
Step 4: Mark top of screen panel
3/4” from each end.
Step 5: Tap in wide filler strip
along top of panel, and align with
marks.
Step 6: Install screen panel by
sliding top in as shown.
Step 7: Slide bottom of screen panel in
place and push snug against post as
shown.
Step 8: Repeat previ-
ous steps to install re-
maining six screen
panels.
© Suncast Corporation Page 01
Step 3: Tap in narrow filler strip
along bottom of panel, and align
with marks.
3/4”
1-13/16”
Note: Steps 2 & 3 are not applicable to wood units.
Screen Panel Installation