Jade Side Table Assembly Instructions Product Dimensions: 27.75” L x 11” D x 34” H Please take a moment to read through the entire instruction booklet before assembly to familiarize yourself with this product. Once you feel ready to start, follow the instructions step by step and this should make this process as easy as we could make it for you.
WARNING ! CAUTION ADULT ASSEMBLY REQUIRED CHOKING HAZARD • This product includes small parts, sharp points and sharp edges in its unassembled state. Keep unassembled parts away from children under 3 years of age, and animals. SAFETY WARNINGS • Follow the information on the warnings appearing on table and on the carton. Do not remove warning label from table. • Do not allow children under 3 years of age to use the table. • Do not use substitute parts.
ASSEMBLY AT A GLANCE Please take a moment to read through the whole instruction booklet before assembly to familiarize yourself withthisproduct . Once you feel ready to start, follow the instructions step by step and thisshould mak e thisprocess as easy as we could make it for you. 1 2 4 3 This drawing is to give you an overall idea only of how this assembly will go together and does not replace the assembly instructions.
COMPONENT PARTS Please check that you have all the parts listed below 1 1. Top Shelf x 1 2. Left Panel x 1 3. Right Panel x 1 4. Bottom Shelf x 1 5. Power Receptacle ×1 5 2 4 3 ASSEMBLY HARDWARE A E CAM Lock 15x11mm x 4 10x10mm x 6 B F CAM Bolt 6x35mm x 4 Knob X 6 C Wood Dowel Pin D Ø8x30mm x 4 G Screw 2.5x12mm x 2 Medium Long Bolt M6x50mm x 6 H Tools Required Hex Screwdriver (included) Phillips Screwdriver (Medium) (not included) *Do Not Use Power Screwdriver or Drill.
ASSEMBLY INSTRUCTIONS B 1 Select 1, 4, B x4, D x2. Turn down the panel 1,insert B x4 into the four corners of the panel 1. Insert D x2 into the both sides middle hole of the panel 4. B D 1 4 B B D 2 Select 2, 3, 4, C×2, D×4,E×4,H×1.Insert E×2 into the left side of panel 4.Insert D ×2 into the top side of the panel 2 with H Allen Wrench into the left side of panel 4.Insert C×1 into the end of the middle hole of the panel 2.Repeat the C×1,D×2 for panel 3.Repeat E×2, D×2 for panel 4.
ASSEMBLY INSTRUCTIONS 3 Select A×4.Insert A×2 into the end of the panel 3. Repeat A×2 for panel 2. A 1 3 A A 4 2 4 H D Install panel 1 into top of the panel 2 and panel 3. Insert E×2 into the inner sides of the panel 1. Insert D×2 into the panel 3 into the panel 1.
ASSEMBLY INSTRUCTIONS 5 Select 5×1.Insert 5 Power Receptacle into the empty of the panel 3. H D 5 1 3 6 Select G×6.Insert G ×4 into the panel 3 into panel 1,4. Insert G × 2 into the end of the panel 2 into the panel 4.
Page 8 of 8