88 5180 31 ; Arts & Crafts . ‘Dining Table IMPORTANT NOTE “ Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damages occurring to the wood pairs, We have taken great care in the design of this product and request that you carefully and strictly Gas follow our assembly instructions to ensure a Joyless) completed product as it was designed. + Casual Attire For Today's Home ne } Lt Leg ips. D. | ? Table Side pes. 2 pes.
BB TE IMPORTANT * Do not tighten up all the screws until each part is properly assembled. * You should keep Hex Wrench, Key Wrench in a safe place as you may need fo tighten up the Bolts in the future. ¥ "Head Gap Bolt Place Top (A) and {B} face side down an a soft cloth.
© Bert ye prong Washer Flat Washer i i Attach Legs (E) to the unit with Flat Washers, Spring Washers lat Washer prong Washer Bolt / Hey Wrench and Bolts see Figure 3. Turn the table over fo its’ upright position. Adding the Leaf STEP 4 Disengage the locks by turning their handles counterclockwise % turn (see Figure 4), Pull out both sides of the table, then place Leaf (C) in the unit as shown, aligning the dowels with the holes.
VERY IMPORTANT !! CARING INSTRUCTIONS NEVER ~NEVER— USE GLASS CLEANERS ON ALLOW LIQUIDS OF ANY KIND TO FINISHED FURNITURE. AMMONIA REMAIN IN DECORATIVE ROUTE LINES. WILL CHEMICALLY ATTACK THE ABSORPTION CAUSES WOOD TO WARP LACQUER. AND FINISHED TO DE-LAMINATE. DONOR Co DO NOT “WRITE K PLACE IN pied DIRECTLY DIRECT ~~ ON SUNLIGHT. SURFACE. PREVENT PREVENT MARKING FADING DO NOT USE DO NOT DO NOT COMMERCIAL PAGE HOT BR USE WAXES AND KETTLES RUBBER POLISHES. POTS, ETC BASED ON SURFACE, PLACE MATS USE CLOTHS.
