LT IMPORTANT Carefully remove all the parts from the carton and place therm individually on a soft cloth to prevent scratches or other damage. Carefully and strictly fol ow these assembly instructions to ensure a completed product as designed. De not use power tools above 8 volts to assemble. 2005503 0042 Night Stand Part List B. Side Panel Side Panel 1pe. H. Back Panel 1 pe. b. Front Rail 1 pe E. Front Rail Refer to later passels) of these 1 pe instructions for drawer assembly. \ 4 h Hardware List Biddy M3
( Assembly Instructions 2/7 ) IMPORTANT » Use a soft cloth between these parts and the floor. + Do not use power tools above 8 volts to assemble. » Do not tighten all the screws unt] each part 's properly assembled, Tha unit must be level to work properly. Use the included adjustable levelers to level.
( Assembly Instructions 3/7 ) STEP 3 Attach Bottom {F) to unit with Dowels and 2" Round Head Screws. STEP 4 Attach Feet (G} to unit, then tighten. HE.
( Assembly Instructions 4/7 ) STEPS Tum unit over to its’ upright position. Attach Top {A} to unit with Cam Locks and 2" Round Head Screws. Cam Lock 2" Lenard Head Screw STEP 6 Level unit by adjusting the adjustable levelers on bottom of unit. (See Figure 2} Note: Unit must be level to proceed. Attach Back Panel (H} to unit with 1/2" Round Head Screws.
( Assembly Instructions Attach Drawer Sides {13} and {14} to Drawer Back {12} with 11/4" Flat Head Screws. STEP 8 Insert Drawer Bottom (15) Into groove. Attach Drawer Front {11} to unit with 11/4" Flat Head Screws. STEP 9 Attach Handle with Machine Screw. Ds Ds Drawer Front rawer Back rawer Side Drawer Side Drawer Bottom Tpe 1pe HE.
( Assembly Instructions 6/7 ) STEP 10 Loosen slightly the screws per-installed on back of drawer front. Bm Ed STEP 11 Insert drawer into unt, then adjust drawer front panel left or right and up or down until drawer gaps look proportional. wv J Pull drawer open slowly and re-tighten screws from Step 10. STEP 12 Make sure drawer front panel does not move and lock drawer front pane! into position with 3/4" Flat Head Screws. Note: These 3/4" Flat Head Screws must be installed to complete the drawer assembly.
