20 05506 0603 King Bed Rails ben IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble. Part List G. Side Panel 2 pes. I Support Hardware List cl eo © M6250 Wx30 Moxie Hood Cap Ult fling) Head Cap Bolt Head Cap Bolt (short) Spring Washer Flat Washer Hex Wrench 12 pes.
( Assembly Instructions 2/6 ) IMPORTANT = Use a soft cloth between these parts and the floor. = Do not use power tools above 8 volts to assemble. » Do not tighten ail the screws until each part is properly assembled, © Keep Hex Wrench and Wrench as the Bolts and Nuts may need to be tightened in the future. ® Do not slide bed on floor. To move assembled bed requires two peoples. Remove any bedding, then lift and carry bed. STEP 1 Insert Bolts into per-drilled holes in Headboard and Foot board, then tighten.
( Assembly Instructions 3/6 ) Flat Washer "8 eo Sing Washer “ay 4 Hegel Cap Bolt long) Arrow Labs| Spring Washer ? Heed Cap Bol {sang) Hex Ranch mmo STEP 2 Figure 1 Note: Supports (H) can be attached at two different levels. Upper vela! is for use with a mattress, Lower level is for use with a box spring and mattress. Orientate Supports {H) so Arrow labels point to the inside, then attach Supports (H) to Side Panels (G) at desired level with Head Cap Bolts (long), Spring Washers and Flat Washers.
( Assembly Instructions 4/6 ) Figure 2 STEP 3 Assemble side panels to Headboard and Foot board with Square Washers and Nuts, tightening Nuts only halfway.
( Assembly Instructions 5/6 ) A Head Cap Bolt (hart) ll STEP 4 Note: Support {I} can be attached at two different levels. Upper level is for use with a mattress. Lower level is for use with a box spring and mattress. Orientate Support so Arrow label points to Headboard, then attach Support to unit at desired level with Head Cap Bolts (short), tightening Head Cap Bolts (short) only halfway. (See Figure 3} 4—— Hex Wrench Figure 3 Tighten Nuts and Head Cap Bolts {short} used in Steps 3 and 4.
( Assembly Instructions 6/6 ) STEP 5 Wrench Attach Slats (J) to unit with Head Cap Bolts and Wood Screws. Tighten Head Cap Bolts with Hex Wrench. {See Figure 4} Note: Do not slide bed on floor. To move assembled bed requires two people. Remove any bedding, then lift and carry bed.
