20 05506 0601 King Headboard Post Post Support 1 pe. 1pe. 1pe. ben IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble. Part List A. Headboard Hardware List Hex mixing (a) Cam Lock Se raw Cam Lock Hed Cap Alt (Lang) Head Cap Boh (short) Spring Washer 6 pes.
( Assembly Instructions 2/4 ) IMPORTANT = Use a soft cloth between these parts and the floor. = Do not use power tools above 8 volts to assemble. » Do not tighten up all the bolts until each part is properly assembled. © Keep Hex Wrench as the bolts may need to be tightened 'n the future. STEP 1 Attach Support (E) to Stretcher {B) with Head Cap Bolts (short). Tighten Head Cap Bolts (short) with Hex Wrench.
( Assembly Instructions 3/4 ) STEP 3 Cam Lock Semester Insert Cam Lock Screws into per-drilled holes in Headboard (A), then tighten. STEP 4 Attach Headboard {A} to unit with Cam Locks. (See Figure 3) Figure 3 WB.
( Assembly Instructions 4/4 ) STEP 5 Attach unit to Posts {C) and (D) with Dowels, Head Cap Bolts {long}, Spring Washers and Flat Washers. Dowel Fiat Washer Spring Washer Head Cap Bolt fling) Tighten Head Cap Bolts {long} with Hex Wrench. (See Figure 4) <0 Fiat Washer 0. Spring Washer , / Head Cap Holt {long} Hex Wrench —» Figured || STEP 6 Turn unit over to its upright position. WB.