I 20 05525 0042 er Ru IMPORTANT Carefully remove all the parts from the carton and place therm individually on a soft cloth to prevent scratches or other damage. Carefully and strictly fol ow these assembly instructions to ensure a completed product as designed. De not use power tools above 8 volts to assemble. Part List oy H Tor Bottom Back Panel 1pe. B. Cc. b. Side Panel Side Panel Front Rail Front Rail Refer to later pages) of these instructions for drawer assembly.
( Assembly Instructions 2/7 ) IMPORTANT » Use a soft cloth between these parts and the floor. + Do not use power tools above 8 volts to assemble. » Do not tighten all the screws unt] each part 's properly assembled, Tha unit must be level to work properly. Use the included adjustable levelers to level. STEP 1 Insert Cam Lock Screws into per-drilled holes in Top {A} and Side Panels (B), (C), then tighten. Attach Side Panels (B) and (C) to Front Rails {D), {E} and Back Rail (F) with Cam Locks.
Assembly Instructions 3/7 STEP 3 and 1 1/4" Round Head Screws. Attach Bottom (G} to unit with Dowels od 11/4" Round Head Screw —— ¢# =) Attach Top {A} to unit with Dowels and Cam Locks.
( Assembly Instructions 4/7 ) STEPS Level unit by adjusting the adjustable levelers on bottom of unit. (See Figure 2) Note: Unit must be level to proceed, Attach Back Panel {H} to unit with 1/2" Round Head Screws.
( Assembly Instructions 5/7 ) STEP 6 Attach Drawer Sides (13) and (14) to Drawer Back (12) with 1 1/4" Flat Head Screws. 7 yt 11/4" Fiat Head Screw Roller at back STEP 7 Insert Drawer Bottom (15) Into groove. Attach Drawer Front {11} to unit with 11/4" Flat Head Screws. STEP 8 Attach Handle with Machine Screws. Note: Drawer assembly is not complete until 3/4” Flat Head Screws are used in a later step.
( Assembly Instructions 6/7 ) STEP 9 Loosen slightly screws per-installed on back of drawer front. — Ser Wy, | Pd] STEP 10 Insert drawer into unit, then adjust drawer front pane! left or right and up or down until drawer gaps look proportional, STEP 11 Pull drawer open slowly and re tighten screws from Step 9. Make sure drawer front panel does not move and lock drawer front pane! into position with 3/4" Flat Head Screws. Note: These 3/4" Flat Head Screws must be installed to complete the drawer assembly.