Assembly Instructions

ManualsBrandsHomestyles ManualsDining ChairsMountain Lodge Gray Dining Chairs (Set Of 2)

Part List

Home Styles Customer Service: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com,

888-680-7460, 877-831-0319

Carefully remove all the parts from the carton and

place them individually on a soft cloth to prevent

scratches or other damage.

Carefully and strictly follow these assembly instructions

to ensure a completed product as designed.

Do not use power tools above 8 volts to assemble.

Hardware List

20 05525 0081

Chair

IMPORTANT

Seat

1 pc.

Leg

2 pcs.

Back Frame

1 pc.

M6x50

Head Cap Bolt

4 pcs. (+1 extra)

M6x70

Head Cap Bolt (long)

4 pcs. (+1 extra)

Small Hex Wrench

1 pc.

M6x40

Head Cap Bolt (short)

3 pcs. (+1 extra)

Flat Washer

11 pcs. (+1 extra)

Hex Wrench

1 pc.

Spring Washer

11 pcs. (+1 extra)

Summary of content (4 pages)

PAGE 1
20 05525 0081 Chair IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble. Part List A. Seat 1 pc. B. Leg 2 pcs. C. Back Frame 1 pc. Hardware List Hex Wrench 1 pc. Spring Washer 11 pcs. (+1 extra) M6x50 Head Cap Bolt 4 pcs. (+1 extra) Small Hex Wrench 1 pc.
PAGE 2
Assembly Instructions 1/2 IMPORTANT Use a soft cloth between these parts and the floor. Do not use power tools above 8 volts to assemble. Do not tighten all the bolts until each part is properly assembled. Keep Hex Wrench as the bolts may need to be tightened in the future. Head Cap Bolt Spring Washer Flat Washer B B A STEP 1 Attach Legs (B) to Seat (A) with Flat Washers, Spring Washers and Head Cap Bolts, tightening bolts only halfway.
PAGE 3
Assembly Instructions 2/2 Flat Washer Head Cap Bolt (long) Spring Washer Spring Washer Head Cap Bolt (short) Flat Washer C STEP 2 Attach Back Frame (C) to unit with Flat Washers, Spring Washers, Head Cap Bolts (short) and Head Cap Bolts (long), tightening bolts only halfway. (See Figures 2 and 3) Tighten all bolts used in Step 1 and 2.
PAGE 4
CARE INSTRUCTIONS NEVER NEVER use glass cleaners on finished furniture. Ammonia chemically attacks the finish. allow liquids to remain on furniture. Absorption causes parts to warp and split and finishes to delaminate. Do not use power tools above 8 volts to assemble. Do not place in direct sunlight. Do not write directly on surface. PREVENT CRACKING PREVENT FADING PREVENT MARKING Do not place hot objects on surface. Do not use rubber based placemats. Do not use commercial waxes and polishes.