88 5530 41 Naples Drawer Chest (White Finish) IMPORTANT NOTE Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damages occurring to the wood parts. We have taken great care in the design of this Fo product and request that you carefully and strictly Fir follow our assembly instructions to ensure a ~ completed product as it was designed. Casual Attire For Today's Home Part List D. Front Piece 3 pes. Cc. Sid Panel 1pc. L KD Drawer 3 pos. K.
Assembly Instructions 2/8 IMPORTANT Do not tighten up all the screws until each part is properly assembled. Figure 1 CH.1922/ 0% / 02 STEP 1 Insert Cam Lock Screws into the per-drilled holes of Side Panel (B) and (C). Attach Front Piece (D) to Side Panel (B) with 1" Round Head Screws.
Assembly Instructions 3/8 Figure 2 STEP 3 Attach Front Piece (E) and Back Pieces Side Panel (B) with Cam Locks. {See figure 2) STEP 4 Slide Back Panels (H) into position. Attach Side Panel (C) to the unit with Cam Locks. Attach Front Piece (D) to Side Panel (C) with 1" Round Head Screws. cH.
Assembly Instructions 4/8 STEP 5 — Insert Cam Lock Screws into the per-drilled holes of Top (A). STEP 6 Place Top (A) onto the unit using Cam Locks & Wooden Dowels. Attach Plinth (F) to the unit using 1 1/4" Round Head Screws & Wooden Dowels.
Assembly Instructions 5/8 ATTENTION! For safety reasons, please follow these instruction to prevent the unit from tipping over. Place the unit on the wall at desired location. Mark with pencil to show the height and center of unit. b Move unit. Drill a 1/4" hole in the wall, 4 inches down and directly below the mark. cH.
Assembly Instructions 6/8 Drawer (K) STEP 1 Attach Base Part (K6) to Front Part (K1) and Back Part (K2). N Attach Side Part (K3) to Front Part (K1) “x and Back Part (K2) using a Phillips ho 5 screwdriver and 1 1/4" Flat Head Screws. Ny ¢ 1104" Fist Head Screw STEP 2 NE Insert Base Part (KS) into the groove. Attach Side Part (K4) to Front Part {K1) and Back Part (K2) using a Phillips screwdriver and 1 1/4" Flat Head Screws. Attach Small Pull Handles with machine screws.
Assembly Instructions 7/8 Drawer (L) 5 Attach Base Part (K6) to Front Part (L1) and Back Part (L2). STEP 1 Attach Side Part (L3) to Front Part (L1) and Back Part (L2) using a Phillips screwdriver and 1 1/4" Flat Head Screws. Insert Base Part (KS) into the groove. Attach Side Part (L4) to Front Part (K2) and Back Part (K4) using a Phillips screwdriver and 1 1/4" Flat Head Screws. Attach Large Pull Handles with machine screws. NN SN ACs Le Front Part Back Part Side Part Side Part Base Part Base Part 3 pes.
Assembly Instructions 8/8 oa Il.IF THE DRAWER ALREADY ALIGNS Pull out drawer slowly. Lock the drawer front panel! into position with 3/4" Flat Head Screws. CH.1922/ THE DRAWER DOES NOT ALIGN Loosen slight the upper screws for Drawer (K) & the lower screws for Drawer (L). STEP 2 Insert the drawer into the main body, then adjust the drawer front panel left or right and up or down, until the drawer gaps look proportional. Pull the drawer open slowly and tighten the upper screws.