20 05533 0042 modesty es . Night Stand IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble. (Part List D. Front Rail 1 pe. A Top E tee Plinth 1pc. F. Back Rail 2 pes. H Base 1pc. G. Back Panel 1pe. B. Cc. I. Side Panel Side Panel Drawer Refer to later page(s) of these 1 pc.
( Assembly Instructions 2/7 ) IMPORTANT « Use a soft cloth between these parts and the floor. « Do not use power tools above 8 volts to assemble. = Do not tighten all the screws until each part is properly assembled. Cam Lock Serape§ STEP 1 Insert Cam Lock Screws into per-drilled holes of Side Panels (B} and {C), then tighten. STEP 2 Attach Front Rail (D) to Side Panel (B} with 1" Round Head Screw. (See Figure 1} Figure 1 STEP 3 Attach Back Rails (F) and Base (H) to Side Panel (B) with Cam Locks.
( Assembly Instructions 3/7 ) STEP 4 Slide Back Panel (G) into place. Attach Side Panel {C) to unit with Cam Locks. Attach Front Rail (D} to Side Panel (C) with 1" Round Head Screw. (See Figure 3) Figure 3 Cam Lock Screw | STEP 5 Insert Cam Lock Screws into per-drilled holes of Top (A), then tighten.
( Assembly Instructions 4/7 ) STEP 6 Attach Top (A) to unit with Cam Locks and Wooden Dowels. Attach Plinth (E) to unit with 1 1/4" Round Head Screws and Wooden Dowels. 11/4" Round Head Screw ‘Wooden Dowel STEP 7 Insert 5/8" Round Head Screws into per-drilled holes of unit, then tighten.
( Assembly Instructions 5/7 ) ON STEP 8 Attach Drawer Side (13) to Drawer Front (11) and Drawer Back (12) with 11/4" Flat Head Screws. 11/4" Flat Head Screw ~ Roller at back STEP 9 Insert Drawer Bottom (15) into groove. Attach Drawer Side (14) to unit with 1 1/4" Flat Head Screws. STEP 10 Attach Handle with Machine Screw. Note: Drawer assembly is not complete until 3/4” Flat Head Screws are used in a later step. Part List Drawer Front Drawer Back Drawer Side Drawer Side Drawer Bottom 1pc 1pe. 1pc.
( Assembly Instructions 6/7 ) STEP 11 Loosen slightly the screws per-installed on back of drawer front. F Any Ad STEP 12 Insert drawer into unit, then adjust drawer front panel left or right and up or down until drawer gaps look proportional. EVA STEP 13 Pull drawer open slowly and re-tighten screws from Step 11. Make sure drawer front panel does not move and lock drawer front panel into position with 3/4" Flat Head Screws. Note: These 3/4" Flat Head Screws must be installed to complete the drawer assembly.
CARE INSTRUCTIONS NEVER NEVER allow liquids 1 remain on furniture, us glass cleaners on Absorption causes parts to warp finished furniture, Ammonia and split and finishes to laminate. chemically attacks the finish. Do not write directly on surface. PREVENT MARKING Do not use power tools above 8 volts to assemble. PREVENT CRACKING 1 Do not page hot objects on surface.
