Installation Guide

SEAT

ASSEMBLY INSTRUCTION

E021C(3A)MOTION CHAIR

1PC

BASE

1PC

4PCS

SCREW

M8x45MM

4PCS

FLAT WASHER

M8x16. 5MM

LOCK WASHER

M8x8.5MM

2PCS

ALU PLATE

This page lists all the contents included in the

box. Please take the time to identify the hardware

as well as the time to individual components to

this product. As you unpack and prepare for

assembly, place the contents on a carpeted or

padded area to protect them from damage.

2PCS

NUT

1PC

WRENCH

PAGE 1
ASSEMBLY INSTRUCTION E021C(3A)MOTION CHAIR LOCK WASHER M8x8.5MM 4PCS F SCREW M8x45MM D G ALU PLATE NUT 2PCS 2PCS FLAT WASHER M8x16.5MM 4PCS 4PCS 1PC 1PC E C B BASE A SEAT H WRENCH 1PC This page lists all the contents included in the box. Please take the time to identify the hardware as well as the time to individual components to this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
PAGE 2
1 Remove all protective packing material and position base on floor. Attach the seat(A) onto the base(B) with Alu plate(G) as the picture, then using screws(C), flat washers(D), lock washers(E) and nuts(F). Be sure to the arrows face to front. Tighten all the bolts and nuts. Test the swivel rocker gently. If the rocker does not rock properly, double check the assembly procedure especially. A A H F B D E C B Cleaning & Care Treat surface with care.