Instructions / Assembly

ASSEMBLY INSTRUCTION

E231C WAVE PATTERN CURVE BACK OFFICE CHAIR WITH TILT

MECHANISM

Gas Lift

Pentagonal Feet

Caster

1pc

5pcs

Seat

Base Cap

Bracket With Handle

1pc

Bolt

Allen Wrench

M6 x 20mm

4pcs

1pc

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly, place the

contents on a carpeted or padded area to protect

them from damage.

PAGE 1
ASSEMBLY INSTRUCTION E231C WAVE PATTERN CURVE BACK OFFICE CHAIR WITH TILT MECHANISM A Gas Lift 1pc D Seat 1pc G Bolt B Pentagonal Feet 1pc C Caster 5pcs E Base Cap F Bracket With Handle 1pc 1pc H Allen Wrench M6 x 20mm M6 4pcs 1pc This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product.
PAGE 2
1 Attach Caster (C) to Pentagonal Feet (B) as shown. 2 Insert Gas Lift (A) and Base Cap (E) into assembled base carefully as shown.
PAGE 3
Attach Bracket With Handle (F) to Seat (D) by using Bolt (G) and Allen Wrench (H) as shown. G F 4 Attach Seat (D) to the chair base as shown. Cleaning & Care Treat surfaces with care. Surfaces are resistant to scratches but are not scratch resistant. Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all connections are tight.