MANUAL GUIDE 1912 Series 36inch
PRE-ASSEMBLY To ensure your installation goes moothly, please read the following instructions carefully before your installation. 1. Removing your old vanity (if applicable). Turn off the electricity and water supply before you start. Then disconnect all lines to the sink and disconnect appliances. 2. Evening out walls and floor Flat, level surfaces are important. Unevenness can cause your vanity to become misaligned resulting in twisting of the cabinet.
ASSEMBLTY 1. Lever the vanity *Use a level and adjustable leg to keep the cabinet level. 2.Position the vanity *Place the vanity in position. Ensure the vanity is flush against to the wall. B 3.Seal the vanity *Apply sanitary silicone sealant between vanity and the wall. Let it sit and dry for 24 hours.
DRAWER REMOVAL AND RE-INSTALLATION INSTRUCTIONS REMOVAL RE-INSTALLATION
