Installation Guide

2
PRODUCT SPECIFICATIONS
SPECIFICATIONS SPECIFICATIONS
Max. ow rate of aerator: 2.2 GPM (8.3 LPM) at 60 PSI 1/4-turn drip-free cartridge
Max. ow rate of hose end: 4.0 GPM (15.1 LPM) at 20 PSI 1/2" solder or female threaded inlets
ASME A112.18.1/CSA B125
Total weight of item: 1.87 lbs.
www.homewerksww.com
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
1
2. Screw threaded leg extensions onto
faucet.
C
2
3. Mount the faucet to the laundry sink
either directly or using a mounting
block (not included).
The two (2) mounting tabs should
face the FRONT of the laundry tub
(over the basin), the single tab
should face the rear of the basin.
C
3
4. Attach the supply lines to the faucet.
Cold to the right side, hot to the left.
Slide the union nuts over the supply
lines.
Install the union tailpieces to each
supply line.
If soldering the supply lines, remove
the rubber O-rings from the union
tailpiece, solder, and replace when
cool. If threading, cover all male
threads with thread sealant tape
(wrapped clockwise), or pipe joint
compound. Attach rmly but do
not over tighten.
C
4
5. Turn water supply or shut off valve
back on and check for leaks.
Remove aerator from spout.
Turn on faucet and run at least 30
seconds to ush out water line. Turn
off water and replace aerator.
REMOVE
AERATOR
5
INSTALLING HOSE AERATOR
1. Turn off water at handles. Use an adjustable plier to
grasp the aerator housing while holding the spout
with your other hand.
2. Rotate aerator to the left to loosen.
3. Remove aerator with ngers.
4. Thread hose aerator onto spout make sure washer
is in place.
5. Tighten hose aerator by turning aerator to the righ
while holding the spout with your other hand.
6. Turn water on at handles. Faucet will work normally
with hose thread aerator in place.