Installation Guide

Eective/Rev Date: July 31, 2010 2www.homewerksww.com
Certications
US
Instructions
Preparation and Assembly
1 2
Locate water supply inlet and shut o water supply valve. These are
usually found under the sink or near the water heater. Remove old
faucet. Clean and dry sink surface area where new faucet will be
mounted.
Place new faucet through holes in top of sink. From underside, slide
washers onto threaded rods. Secure with washer and nuts.
3 4
Connect water supply lines.
(A) Use 1/2" IPS faucet supply lines or use coupling nuts (not supplied)
with ball-nose risers (not included).
Turn water supply or shut-o valve back on and check for leaks. If
leaks occur, gently tighten the faucet connections.
Important: After installation is completed, remove aerator. Turn on
water supply and allow both hot and cold water to run for at least
one minute each. While water is running, check for leaks. Replace
aerator. Tighten nuts slightly to stop minor leaks. If problems persist,
refer to troubleshooting chart.
NOTE: To use with hose, remove aerator housing. Attach hose with 3/4" garden hose adapter to aerator.
Two Handle Laundry Tray Faucet
623662  Chrome
16-U42-WNCH-B – Chrome