Instructions / Assembly

2
www.HomewerksWW.com
D
7.1
7
E
5
PRODUCT SPECIFICATIONS
Maximum Flow Rate: 1.8 GPM (6.8 LPM) at 80 PSI
Chrome nish
Total weight of item: 1.706 lbs.
A112.18.1M – 1.8 GPM (6.8 LPM) max at 80 PSI
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve or at the main supply.
Disconnect the supply lines to
the faucet and remove the old
faucet.
If you do not have a separate
on/off valve to control the
utility shower, we recommend
installing one (not included)
before continuing.
1
6 . Using 1/2 inch male adapters,
attach the hot and cold water
supply lines. Hot should go on
the LEFT side when you are
looking at the faucet body (E)
WARNING: DO NOT use with
only a hot water hook-up.
Serious scalding will occur.
2. Wrap thread seal tape (2.1) in a
clockwise direction or use pipe
thread compound to cover all
exposed male threaded areas.
Measure the desired position of
the shower kit so the handles
will be at a comfortable height
and the handle assembly has
a solid surface, like a 2x4 or
concrete block, to mount to.
Usually the faucet body (A) will
be 3 - 4 ft. above the ground.
7. Mount the faucet body (E) to a
solid surface using anchors or
screws (not included) inserted
through the mounting ears
(7.1).
Attach the soap dish (C) to the
wall at the desired distance
from the faucet body (E) using
the mounting screws (D).
3. Determine if the water supply
is coming from above or below
the faucet body (E). If coming
from above, proceed to the next
step. If coming from below, use
a wrench to remove the diverter
plug (3.1) in the faucet body (E).
Wrap the threads of the diverter
plug (3.1) in thread seal tape
or pipe joint compound. Place
the diverter plug (3.1) in the
opposite plug opening (3.2).
Tighten rmly.
8. Turn on the water supply to
the shower. Rotate both
handles (8.1) to turn on the
shower. Flush the hot and cold
water supply lines for 30
seconds to remove any debris
from the lines. Check for leaks
and tighten any areas that are
leaking. Turn off the shower.
4. Slide the soap dish (C) over the
shower arm (B). Make sure the
mounting tabs (5.1) on the soap
dish (C) are pointing up toward the
bend in the shower arm (B).
9. Attach the showerhead (A) to
the shower arm (B) by
tightening it in a clockwise
direction with a wrench.
Do not overtighten. Use a
cloth to protect the nish of
the showerhead (A).
5. Thread the base of the shower
arm (B) onto the faucet body
(E). Twist until it is tight, making
sure the shower arm (B) outlet is
pointing away from the wall.
2
6
Ground Level
3 ft. - 4 ft.
3
C
B
5.1
4
2.1
C
COLDHOT
HOT
COLD
9
8
B
A
C
8.1
8.1
3.1
3.1
3.2
E
3.2
E
E
B