Installation Guide

ManualsBrandsHOMLUX ManualsIn Stock Kitchen CabinetsEasy-DIY 9 in. W x 12 in. D x 42 in. H Ready to Assemble Wall Kitchen Cabinet in Shaker White

Table Of Contents

ASSEMBLY INSTRUCTION

PART

DESCRIPTION

QTY

PART

DESCRIPTION

QTY

Box side panel - left 1

Box side panel - right 1

Box bottom panel

Box back panel

WALL CABINET

MODEL#

W0942 W1242 W1542 W1842 W2142

Estimated Assembly Time: 30 - 40 minutes

2-person assembly recommended

Rubber bumper x 2 Adjustable shelf clip x 12

TOOLS REQUIRED

1/6

D Face frame & door panel

K Adjustable shelf

L Box top panel

1″ Flat head phillips screw x 4

HARDWARE CONTENTS

Summary of content (6 pages)

PAGE 1
ASSEMBLY INSTRUCTION TOOLS REQUIRED WALL CABINET MODEL# W0942 W1242 W1542 W1842 W2142 Estimated Assembly Time: 30 - 40 minutes 2-person assembly recommended PART A1 A2 B C DESCRIPTION Box side panel - left Box side panel - right Box bottom panel Box back panel QTY 1 1 1 1 PART D K L DESCRIPTION Face frame & door panel Adjustable shelf Box top panel HARDWARE CONTENTS DD Rubber bumper x 2 EE Adjustable shelf clip x 12 1/6 FF 1″ Flat head phillips screw x 4 QTY 1 3 1
PAGE 2
ASSEMBLY INSTRUCTION 1 2 3 4 5 6 7 8 2/6
PAGE 3
CAMLOCK CONNECTION 1. Insert the camlock to the locker. 2. Turn the nut clockwise to latch two parts.
PAGE 4
REVERSE DOOR INSTRUCTION 1. Remove the 3/4" round head Phillips screws from each hinge and take out the door panel. 2. Reverse the door panel and drill the 3/4” round head Phillips screws into each hinge through the pre-drilled holes to tighten the hinge to the cabinet frame. 3. If the door is not level when it is installed, the customer will need to turn the screw clockwise to extend the hinge or counterclockwise to shorten the hinge.
PAGE 5
ADJUSTABLE SHELF INSTALLATION 1. Insert four shelf clips into the pre-drilled holes on the inner side of cabinet box side panels at the same height for one shelf. EE EE 2. Insert the adjustable shelf at a tilted angle.
PAGE 6
FASTEN BOX BOTTOM PANEL AND BOX BACK PANEL 1. Drill 1” flat head Phillips screw to the predrilled holes and fasten box bottom panel with box back panel FF RUBBER BUMPER INSTALLATION 1. Attach rubber bumpers to 4 corners of each drawer face panel and 2 outsider corners of each door panel.