User's Manual
Table Of Contents
- Cover
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Marvell Wireless Configuration Utility Overview
- 3 Marvell Wireless Configuration Utility User Interface
- 3.1 Network Status Tab
- 3.2 Profile Manager Tab
- 3.3 Site Survey Tab
- 3.4 Statistics Tab
- 3.5 Advanced Tab
- 3.6 AutoLink Tab
- 3.7 Admin Tab
- 3.8 About Tab
- A Compliance Statements
- B Acronyms and Abbreviations
- C Revision History
- Back Cover
Marvell Wireless Configuration Utility User Interface
Profile Manager Tab
Copyright © 2007 Marvell CONFIDENTIAL Doc. No. MV-S800477-00 Rev. B
August 14, 2007, 2.00 Document Classification: Proprietary Information Page 27
2. Select the required Key Format and Key Size.
3. Enter the Transmit Key(s).
4. Click OK to return to the Security tab of the Profile Settings.
5. Select the WEP key to be used for the transmission.
6. Click Save to set the configuration.
Note
Up to four WEP keys are supported. The WEP key used for the transmission must be
identical on the sending and receiving station.
Figure 18: WEP Key Setting
Table 5: WEP Key Configuration Window Description
Field Description
Key Format Either ASCII characters or hexadecimal digits
Key Size
• 40-bit, 5 character ASCII key size (40-bit, 10 hexadecimal digits)
• 104-bit, 13 character ASCII key size (104-bit, 26 hexadecimal digits)
Transmit Key/Key Value Key to be used as transmit key. The key value is in ASCII or hexadecimal,
depending on the format selected. The key value size shown depends on
the key size selected.