User's Manual
Table Of Contents
- Cover
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Marvell Wireless Configuration Utility Overview
- 3 Marvell Wireless Configuration Utility User Interface
- 3.1 Network Status Tab
- 3.2 Profile Manager Tab
- 3.3 Site Survey Tab
- 3.4 Statistics Tab
- 3.5 Advanced Tab
- 3.6 AutoLink Tab
- 3.7 Admin Tab
- 3.8 About Tab
- A Compliance Statements
- B Acronyms and Abbreviations
- C Revision History
- Back Cover
CB-85/MB-85/EC-85/MC-85
User Guide
Doc. No. MV-S800477-00 Rev. B CONFIDENTIAL Copyright © 2007 Marvell
Page 52 Document Classification: Proprietary Information August 14, 2007, 2.00
3.2.5 Profile Setting—Protocol Tab
The Protocol tab allows you to set or change the protocol information.
Do not change settings
If this check box is selected, the protocol setting is not changed when the profile is applied.
Use below settings
If the Do not change setting check box is not selected, the protocol settings include the following
parameters.
Figure 40: Protocol Tab
Table 18: Protocol Tab Description
Field Description
Power Save Mode Sets the power mode. Available options are Continuous Access or Max
Power Save. The default setting is Continuous Access.
Preamble (802.11b) Sets the Radio Preamble to Auto, Short or Long.
Transmit Rate The range of the data rate depends on the type of AP that the client card
is connected to. The default setting is Auto Select.
MCS index will be allowed to select when the 802.11n Network check
box in the Network Info tab is selected.
Fragment Threshold Sets the fragmentation threshold (the size that packets are fragmented
into for transmission). The default setting is 2346.
RTS/CTS Threshold Sets the packet size at which the AP issues a Request-To-Send (RTS) or
Clear-To-Send (CTS) frame before sending the packet. The default
setting is 2347.
Reset Resets the protocol settings to their default values