User's Manual
Table Of Contents
- Cover
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Marvell Wireless Configuration Utility Overview
- 3 Marvell Wireless Configuration Utility User Interface
- 3.1 Network Status Tab
- 3.2 Profile Manager Tab
- 3.3 Site Survey Tab
- 3.4 Statistics Tab
- 3.5 Advanced Tab
- 3.6 AutoLink Tab
- 3.7 Admin Tab
- 3.8 About Tab
- A Compliance Statements
- B Acronyms and Abbreviations
- C Revision History
- Back Cover
Compliance Statements
Federal Communications Commission (FCC) Compliance
Copyright © 2007 Marvell CONFIDENTIAL Doc. No. MV-S800477-00 Rev. B
August 14, 2007, 2.00 Document Classification: Proprietary Information Page 65
A Compliance Statements
A.1 Federal Communications Commission (FCC)
Compliance
A.1.1 Transmitter Module Approval Conditions
Antennas must be installed to provide 20 cm separation distance from the transmitting antenna
to the body of the user during normal operating condition. This device must not be co-located or
operating in conjunction with any other antenna or transmitter.
Only those antennas filed under FCC ID:MCL74487604 can be used with this device.
When the module is installed in the final system where the antenna location is less than 20 cm
separation distance to the body of user, additional equipment authorization must be applied.
FCC ID label on the final system must be labeled with “Contains FCC ID:MCL74487604” or
“Contains transmitter module FCC ID:MCL74487604”.
In the user guide, final system integrator must be ensure that there is no instruction provided in
the user guide to install or remove the transmitter module.
The transmitter module must be installed and used in strict accordance with the manufacturer's
instructions as described in the user documentation that comes with the product. This device
complies with the following radio frequency and safety standards.
A.1.2 USA-Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy. If not installed and used in accordance with the instructions, it may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by tuning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and the receiver.
Connect the equipment to outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Modifications
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Caution
Exposure to Radio Frequency Radiation
To comply with FCC RF exposure compliance requirements, a separation distance of at
least 20 cm must be maintained between the antenna of this device and all persons.
This device must not be co-located or operating in conjunction with any other antenna
or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Operations in the 5.15-5.25 GHz band are restricted to indoor usage only.