User's Manual
Table Of Contents
- Cisco Edge 340 Series Installation Guide
- About this Guide
- Cisco Edge 340 Series Accessories
- Overview of the Cisco Edge 340 Series
- Installing the Cisco Edge 340 Series
- Powering On the Cisco Edge 340 Series
- Resetting to Factory Mode
- Technical Specifications
- Regulatory Standards Compliance
- EMC Class B Notices, Warnings, and Safety Information
- Statement 2018-Class B Notice for FCC
- Statement 2022-Class B Notice for Canada
- Canadian Compliance for the Cisco Edge 340 Series
- Statement 295-Class B Warning for Korea
- Korea Application Statement
- Statement 157-VCCI Compliance for Class B Equipment
- Compliance Statement for Taiwan
- Compliance Statement for Device Working at 2.4 G and 5G in Brazil
- FCC Radiation Exposure Statement
- Declaration of Conformity for RF Exposure
- Obtaining Documentation and Submitting a Service Request
8
Cisco Edge 340 Series Installation Guide
OL-29523-01
Installing the Cisco Edge 340 Series
• Humidity around the Cisco Edge 340 does not exceed 85 percent.
• Altitude at the installation site is below 2000m.
Warning Statements
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 7.9 inches (20 cm) or more from the body of all persons.
Statement 332
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than:
20A
Statement 1005
Warning
The plug-socket combination must be accessible at all times, because it serves as the main
disconnecting device.
Statement 1019
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection:
10/100/1000 Ethernet
Statement 1044
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this
device.
Statement 1071
SAVE THESE INSTRUCTIONS