User's Manual
Table Of Contents
- Cisco Edge 340 Series Installation Guide
- About this Guide
- Cisco Edge 340 Series Accessories
- Overview of the Cisco Edge 340 Series
- Installing the Cisco Edge 340 Series
- Powering On the Cisco Edge 340 Series
- Resetting to Factory Mode
- Technical Specifications
- Regulatory Standards Compliance
- EMC Class B Notices, Warnings, and Safety Information
- Statement 2018-Class B Notice for FCC
- Statement 2022-Class B Notice for Canada
- Canadian Compliance for the Cisco Edge 340 Series
- Statement 295-Class B Warning for Korea
- Korea Application Statement
- Statement 157-VCCI Compliance for Class B Equipment
- Compliance Statement for Taiwan
- Compliance Statement for Device Working at 2.4 G and 5G in Brazil
- FCC Radiation Exposure Statement
- Declaration of Conformity for RF Exposure
- Obtaining Documentation and Submitting a Service Request
9
Cisco Edge 340 Series Installation Guide
OL-29523-01
Installing the Cisco Edge 340 Series
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of:
113°F (45°C)
Statement 1047
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning
To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
3 inches (7.6 cm)
Statement 1076
Caution Be aware of the size and weight of the Cisco Edge 340 Series when mounting. Ensure that the mounting
location has a stable flat surface and can safely support the weight of the Cisco Edge 340 Series.
Installing the Cisco Edge 340 Series on a Wall, Pole, or Ceiling
Warning
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system.
Statement 378
You can use the wall-mount kit to mount the Cisco Edge 340 Series to:
• A wall or pillar (concrete, plaster, or drywall)
• A suspended grid ceiling T-joint
• A metal pole
For more information and detailed installation procedures, see Mounting the Kit Assembly (Wall, Pole,
and Ceiling Mount) for Cisco Edge 340 Series.
Install the Cisco Edge 340 Series on a Flat-Panel Display
You can use your display-mounting kit to install a Cisco Edge 340 to almost any VESA-compliant
flat-panel display that is attached to a third-party VESA bracket. You can mount your Cisco Edge 340
Series above or below the flat-panel display, whether the display is oriented in landscape mode
(horizontal) or portrait mode (vertical).
Note See the manufacturer documentation pertaining to your display to learn if its casing is VESA compliant
and, if it is, where you can obtain a compatible VESA bracket for it. Cisco does not sell VESA brackets
or kits.
The LCD-mount plates for this product might not be long enough to mount your mounting kit to an
extremely large flat-panel display even if that display is VESA compliant.
For more information and detailed installation procedures, see Mounting the Kit Assembly (Display
Mount) for Cisco Edge 340 Series.