User's Manual

DB 6520
© (2014) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
14 Router Installation
from the Data Gateway its own IP Address automatically: in such a case, the
Data Gateway acts like the DHCP server in your local network.
TCP/IP CONFIGURATION
To access the Internet through the Data Gateway, you must configure the net-
work settings of the computers on your LAN to use the same IP subnet as Data
Gateway. The default IP settings for the Data Gateway are:
IP ADDRESS: 192.168.1.1
SUBNET MASK: 255.255.255.0
These settings can be changed to fit your network requirements, but you must
first configure at least one computer to access the Data Gateway's web configu-
ration interface in order to make the required changes.
ETHERNET CONNECTION
>> TCP/IP PROTOCOL
INSTALLATION
This procedure requires the TCP/IP protocol installed on your computer. Refer
to the following paragraphs and to your Windows and MacOS operating sys-
tems manuals.
Microsoft Windows Vista / Windows 7
TCP/IP stack is considered a core component of the operating system, so it
cannot be installed or uninstalled. You must check in this case that Internet Pro-
tocol (TCP/IP) is enabled. To do so, follow these steps:
1. Starting from Start -> Control Panel -> Network & Internet -> Network Con-
nections depending on the configuration of your computer.
2. Select the Network Adapter icon and from the contextual menu, do select the
Properties item.
3. In the General TAB panel, verify that Internet Protocol v4 (TCP/IPv4) item is
checked; if not, do check it and click on the OK button.
Microsoft Windows XP
TCP/IP stack is considered a core component of the operating system, so it
cannot be installed or uninstalled. You must check in this case that Internet Pro-
tocol (TCP/IP) is enabled. To do so, follow these steps:
1. Starting from Start -> Settings -> Control Panel or Start -> Control Panel de-
pending on the configuration of your computer.
2. Make a double click on the Network Connections icon.
3. Select the Network Adapter icon and from the contextual menu, do select the
Properties item.
4. In the General TAB panel, verify that Internet Protocol (TCP/IP) item is
checked; if not, do check it and click on the OK button.