User's Manual

DB 6520

Router Installation 21

FIGURE 10. Network panel on MAC OS 10.x

WI-FI CONNECTION

It requires a computer with 802.11b/g/n (Wi-Fi Certified) wireless adapter installed.

1. Install your wireless adapter according to the manufacturer’s instructions

and verify that your computer is set to obtain an IP address automatically

(DHCP mode).

2. Upon wireless adapter installation and driver setup, please check in the

Network Connections panel – accessible through your OS Control Panel –

that the Wireless Network Connection is enabled. If not, enable it by right

clicking on the Wireless Network Connection item and by selecting “Enable”.

3. In case of an hardware wireless switch, please check that it is set to ON.

Usually a steady lighted or flashing led will notify you the wireless connection

up. Please consult your PC or notebook manual to get information on proper

hardware switching and related led behavior.

You will need to properly configure your adapter to communicate with the DB 6520 according to the

configuration rules.

4. An icon will be shown in the quick tray icon bar at the bottom of your screen

to notify you the current wireless connection state (see Figure 12)