User's Manual

DOC 256712 rev 0.1 4 1
If trouble is experienced with this VDSL/GbE WiFi Data Router for repair or warranty
information, please contact:
Company Name: COSTAR
Address: 518 VALLEY WAY MILPITAS CA 95035 USA
Tel. No: 408-946-9339
If the equipment is causing harm to the telephone network, the telephone company may
request that you disconnect the equipment until the problem is resolved.
Connection to party line service is subject to state tariffs. Contact the state public utility
commission, public service commission or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure
the installation of this equipment does not disable your alarm equipment. If you have
questions about what will disable alarm equipment, consult your telephone company or a
qualified installer.
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO
EMERGENCY NUMBERS:
1) Remain on the line and briefly explain to the dispatcher the reason for the call.
2) Perform such activities in the off-peak hours, such as early morning or late evenings.
End of life disposal
The crossed-out wheeled bin symbol on the Product or on its packaging indicates
that this Product must not be disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it
over to a designated collection point for the recycling of waste electrical and
electronic equipment, or to return it to the dealer when purchasing a new
appliance.
The separate collection and recycling of your waste equipment at the time of
disposal will help to conserve natural resources and ensure that it is recycled in a
manner that protects human health and the environment and supports the reuse
and/or recycling of materials the equipment is made of.
For more information about where you can drop off your waste equipment for
recycling, please contact your local city office or your household waste disposal
service.
The unlawful disposal of the product by the user may entail a fine.
Waste packaging should be separated and delivered at the collection points in
accordance with the local waste collection rules.
FINAL REMARKS
This Product must be installed and used in strict accordance with the manufacturer’s
instructions as described in the enclosed user documentation.
In some cases the use of wireless devices could be limited by the proprietary or
representative of the building. In case of doubts about the disposals and rules regarding the
use of wireless devices in specific environment (ex. airports and hospitals), it is
recommended to ask the authorization before using the Product.
ADB Broadband S.p.A. is not responsible for any radio or television interference caused by
unauthorized modification of this device, or the substitution or attachment of connecting
cables and equipment other than specified by ADB Broadband S.p.A. The correction of
interference caused by such unauthorized modification, substitution or attachment will be the
responsibility of the user. ADB Broadband S.p.A. and its authorized resellers or distributors
are not liable for any damage or violation of government regulations that may arise from the
user failing to comply with these guidelines.
Manufactured by ADB Broadband S.p.A.
P.IVA: 04566350965
Viale Sarca, 222 – 20126 Milano
For further information http://adbglobal.com
REGULATORY COMPLIANCE AND SAFETY INFORMATION
Before any operation is performed, please read the operation instructions and
precautions carefully in order to minimize the possibility of accidents.
When you use this Product you shall always respect basic safety measures in order to
reduce risk of fire, electric shock or injury, following below instructions.
Environmental conditions for Product installation and use
The Product shall be installed and configured in accordance with the user guide.
The Product shall be used and installed indoor with a maximum ambient
temperature of 45 °C and a minimu temperature of -5 °C.
The Product shall be installed in a place with a grade 2 of environmental pollution
(a place without conducting polluting agents).
The Product shall not be placed near any source of heat or direct sunlight.
The Product shall be placed in a well-ventilated area in order to prevent
overheating. Do not cover or block the air vents on the Product. These are
necessary for proper ventilation.
Do not use this Product near water or in close proximity to bath tub, wash bowl,
kitchen sink, or laundry basin, in a wet basement, or near a swimming pool.
The Product Shall not get in contact with water and moisture. Moving the Product
from a cold environment to a hot one may cause moisture on some internal parts
of the device. Wait until the Product is totally dry before turning it on. In case of
fire, do not use water for fire-extinguishing.
The Product shall not be used during a lightning storm. There is a remote risk of
electric shock from lightning.
Interface classification
The external interfaces of the Product are classified as:
xDSL: TNV-3 circuit subject to overvoltages.
xDSL port is classified as TNV-3 circuit. This means that although the cables to be
used for the normal connection in accordance with the installation procedures are
subject to overvoltages, the safety standard are respected.
The other telecommunication ports (Ethernet, HCNA and USB Host) and the low
voltage power supply port: SELV circuit.
External xDSL cables must be connected only to xDSL port. Where these cables
were connected to other ports of the Product does not comply with safety
standards, there may be overvoltages problems.
Ethernet ports must be connected only to devices that support the same kind of
interface, and the cable used must not leave the building where the Product is
installed.
Wireless LAN
The Product is provided with a Wi-Fi interface based on DSSS (Direct Sequence
Spread Spectrum) and OFDM (Orthogonal Frequency Division Modulation) radio
technologies. The Product complies with the IEEE 802.11a/b/g/n standard and is
Wi-Fi Certified
TM
according to Wi-Fi Alliance.
USB
The equipment has to be connected to a standard USB device compliant with
limited current circuit (as per UL 60950-1/CSA C22.2 No. 60950-1).