User Manual

Internal Modem
Hardware Guide 6–7
3. Select your location, then select the Edit button.
4. Select the Tone or Pulse radio button.
5. Select the OK button > OK button.
Check the Telephone Number
Dial the telephone number on the telephone, verify that the
remote modem is answering, then hang up.
Check the Dial Tone
If the modem receives a dial tone it does not recognize, it will not
dial and will display a No Dial Tone error message.
■ To set the modem to ignore all dial tones before dialing:
1. Select Start > Control Panel > Network and Internet
Connections category.
2. From the See Also menu in the left column of the
window, select Phone and Modem Options >
Modems tab.
3. Select your modem > Properties button > Modem tab.
4. Clear the Wait For Dial Tone Before Dialing check box.
5. Select the OK button > OK button.
■ If you continue to receive the No Dial Tone error message
after clearing the check box:
1. Select Start > Control Panel > Network and Internet
Connections category.
2. From the See Also menu in the left column of the
Network and Internet Connections window, select Phone
and Modem Options > Dialing Rules tab.
3. Select your location, then select the Edit button.
4. Select your location from the Country/Region list.
✎
If you select a country or region that is not supported by the
modem, the country configuration defaults to USA or UK.
5. Select the OK button.
331734-001.book Page 7 Monday, July 14, 2003 3:47 PM