User Manual

2
Operating Voltage 3.3VDC
Radio On / Off
Dynamic Rate Shifting Automatic fallback
Network Architecture Ad-hoc, Infrastructure
Operating Systems Windows 98/Me/2000/XP
Mechanical Requirements Mini-PCI Type IIIB dimension.
1.2:FCC Notice
1.2.1 FCC Class B Statement
This equipment has been tasted and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions, may cause
harmful interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on , the user is encouraged to try to correct the interferencr by one or more of the following measures:
! Reorient or relocate the receiving antenna
! increase the separation between the equipment and the receiver
! Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
! Consult the dealer or an experienced radio/TV technician for help
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or
antenna.
As long as the 2 conditions above are met, further transmitter testing will not be required. However,
the OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
The OEM integrator is required to label their end product using this module by the warning statement
such as “This product integrate an RF module with FCC ID: MCLT60H656”.
The OEM integrator is not allowed to use the antenna which is not included in this authorization. Also
the warning statement of the use of the antenna which is not approved in this authorization should be
also included in the users manual of the end product.
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and
Obtaining a separate FCC authorization.