INSTALLATION MANUAL T60H928.
Contents SECTION ONE: 1.1 INTRODUCTION............................................................................................ 1 FEATURES .............................................................................................................................. 1 1.1.1 BLUETOOTH FUNCTION ............................................................................................................... 1 1.1.2 MODEM FUNCTION ..............................................................................
Section One: Introduction The Bluetooth Module use a monolithic single-chip, Broadcom BCM2045 and it can compliant Bluetooth 2.0.This Bluetooth module is base on the highly integrated BCM2045 stand-alone baseband processor with an integrated 2.4GHz transceiver. It is fully compliant with the Bluetooth radio specification and incorporates new modulation schemes to support enhanced data rate(EDR) of 3MBps. 1.1 Features 1.1.
Pico Net 1 master to 7 slaves Operating Channels 79 channels of 1 MHz BW Security Full support of Bluetooth security provisions including hardware support for full length 128 bit encryption keys. Host Interface (USB) USB specification 1.1 compliant and using MDC reserve pin to communicate with Host Software Requirements Windows 98SE, ME, 2000, XP.
Section Two: Bluetooth Installation The following steps provide instructions for installing Bluetooth. 1. Make sure your Bluetooth device already insert into your notebook. 2. Make sure your notebook operating system support Windows 98SE or ME or 2000 or XP. 2.1 Bluetooth Installation Proceed to the following section. 1. Double click the program “Setup.exe” to execute the setup procedure in the software package： 2.
3. Windows shows the welcome dialog as below, click the “Next” to begin the process： 4. The license agreement dialog will pop up, please read it carefully.
5. Specify the destination folder in your local system, which you want the software install to. You may use the default folder or click “Change” to install to different folder, then click “Next”： 6. The dialog “Ready to install the program” shows.
7. Windows shows the dialog as below indicate the driver software in installing： 8.
. Setup program detects the Bluetooth device and setups property driver for it： 10.
11. Finished the installation, you must restart the system to effect settings, click “Yes”： 12.
13.
Section Three: FCC Notice 3.1 FCC Notice Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users, and The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
