Product Specs

WBU063-VZ
18
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the FCC authorization is no longer considered valid
and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator
will be responsible for reevaluating the end product (including the transmitter) and obtaining a
separate FCC authorization.
The module is tested for standalone mobile RF exposure use condition. Any other usage
conditions such as co-location with other transmitter(s) or being used in a portable condition
will need a separate reassessment through a class II permissive change application or new
certification.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed
such that 20 cm may be maintained between the antenna and users. The final end product must
be labeled in a visible area with the following: “Contains FCC ID: RX3-WBU063VZ”. The grantee's
FCC ID can be used only when all FCC compliance requirements are met.
Antennas
The following antennas have been certified for use with this module; antennas of the same type
with equal or lower gain may also be used with this module. The antenna must be installed such
that 20 cm can be maintained between the antenna and users.
WLAN Type : PCB, Internal
BT Type : PIFA, External