User's Manual

7
Get Started: Installation
LoRa module is a wireless transceiver which provides an easily
controllable CMD interfaces(CLI/UART) that the user would send data
quickly with wireless communication protocol. Prepare only one usb
cable, users could use any kind of terminal utilities such as TeraTerm,
Putty and HyperTerminal to access the CMD interfaces(CLI/UART).
1. Hardware introduction
As the following figures, you can see a LoRa module mounted on a
debugger board. The red frame indicates the main interfaces on the
debugger board, includes UART, ADC and SPI and so on.
2. Connect to the computer
Use a micro USB cable to connect to the computer with debug board.
When it is connected, the power LED will turn on.
USB to UART
Power LED
GND
D
ADCx4
SPI
Antenna
UART TX/RX