Lateral File Instructions

ManualsBrandsHON ManualsDrawer Filing Cabinets600 Series 2-Drawer Lateral Filing Cabinet

600 SERIES LATERAL AND SHELF FILE LABEL HOLDER

42-2303B

(2/95)

Installation:

1. Refer to Illustration 1. Place bottom lip

of label holder onto bottom edge of

drawer pull.

2. Refer to Illustration 1. While applying

downward pressure to top of label hold-

er, push inward until label holder snaps

into place.

3. Slide label holder either to the left or

right side of drawer pull.

4. Refer to Illustration 2. Insert label into

label holder by sliding label into label

holder grooves.

Tools required for assembly:

None

Read all instructions and review illustra-

tions before installing.

This assembly includes:

Label holder

Label

Drawer front

Drawer pull

Label holder

Drawer front

Drawer pull

Label holder

Label

NOTE

To allow access to the drawer pull, the label

holder must be positioned to either side of

drawer pull.

Grooves

Illustration 1

Illustration 2

INSTALLATION INSTRUCTIONS

Summary of content (5 pages)

PAGE 1
600 SERIES LATERAL AND SHELF FILE LABEL HOLDER Read all instructions and review illustrations before installing. Drawer front Tools required for assembly: None Drawer pull Label holder This assembly includes: Label holder Label Installation: 1. Refer to Illustration 1. Place bottom lip of label holder onto bottom edge of drawer pull. 2. Refer to Illustration 1. While applying downward pressure to top of label holder, push inward until label holder snaps into place.
PAGE 2
INSTALLATION AND USE MANUAL FOR LATERAL FILES Please return this manual to the orange storage pocket in the bottom drawer. WARNING AN IMPROPERLY INSTALLED FILE CABINET CAN BECOME UNSTABLE OR TIP OVER, CAUSING SERIOUS INJURY. FOLLOW ALL INSTRUCTIONS IN THIS MANUAL FOR CORRECT INSTALLATION, USE, AND MAINTENANCE. These files are for storing and filing non-combustible materials that do not require special protection. Do not use this cabinet to store combustible or hazardous materials.
PAGE 3
LOADING AND UNLOADING WARNING An improperly loaded or unloaded file cabinet can become unstable or tip over, causing serious injury. Loading: 1. Check cabinet for proper adjustment and stability. 2. Load bottom drawer first to increase stability. 3. Distribute contents and weight evenly among remaining drawers. 4. Check to see if cabinet is stable after loading is complete (on carpeted surfaces, settling may occur). If necessary, empty cabinet completely, then readjust glides. Unloading: 1.
PAGE 4
HANGING FOLDER FRAMES There are two hanging folder frames per drawer.
PAGE 5
OPTIONAL DIVIDERS Plate Divider: 1. With lower tab pointing down and rear tabs pointing toward rear of drawer, lay divider flat on bottom of drawer. Divider Lower tab Rear tab 2. Insert lower tab into the desired slot on the bottom of drawer and pivot top of divider upward. 3. Align rear tabs with slots on rear of drawer. 4. Push divider toward rear of drawer until rear tabs lock into slots. 5. Reverse procedure to remove divider.