Automobile Accessories User Manual

10 of 12 All 21624 (0008) © 2000 American Honda Motor Co., Inc - All Rights Reserved.
33. Remove the clip from the hole in the left knee
bolster, use a utility knife to cut the clip off of the
vehicle harness. Take care not to damage the
vehicle harness.
34. Assemble three fuse cases as shown. Attach the
appropriate fuse label to each fuse case of the
security system wire harness, then attach the red
connector clip as shown.
37. Position the 5-pin and 4-pin relays onto the other
relay bracket, and install one 6 x 12 mm
washer-bolt and 6 mm nut.
35. Position one of the relay brackets on the left knee
bolster, and install one 6 x 12 mm washer-bolt and
6 mm flange nut. Push the red connector clip on
the fuse case of the security system wire harness
into the hole in the relay bracket.
38. Plug the 6-pin and 4-pin connectors of the security
system wire harness into the 5-pin and 4-pin
relays; then attach the relay bracket to the steering
hanger beam with one 6 x 12 mm washer-bolt and
6 mm flange nut. (The 5-pin relay has a 6-pin
connector.)
LEFT KNEE
BOLSTER
VEHICLE
HARNESS
HARNESS CLIP
(Cut and discard.)
FUSE SEAL
(15 A)
FUSE SEAL
(3 A)
6 x 12 mm
WASHER-BOLT
RELAY
BRACKET
LONG
WIRE TIE
RED
CONNECTOR
CLIP
LEFT
KNEE
BOLSTER
FUSE
CASE OF
SECURITY
SYSTEM
WIRE
HARNESS
VEHICLE HARNESS
6 mm
FLANGE NUT
6 mm
FLANGE
NUT
4-PIN RELAY
5-PIN RELAY
5-PIN RELAY
6 x 12 mm
WASHER-BOLT
RELAY BRACKET
About 45°
5-PIN RELAY
6-PIN CONNECTOR
4-PIN
RELAY
4-PIN
CONNECTOR
5-PIN
RELAY
6 x 12 mm
WASHER-
BOLT
STEERING HANGER BEAM
6 mm
FLANGE
NUT
4-PIN
RELAY
36. Secure the security system wire harness to the
vehicle harness with one long wire tie in the area
shown.