Automobile Accessories User Manual

12 of 12 All 21624 (0008) © 2000 American Honda Motor Co., Inc - All Rights Reserved.
49. Check that all wire harnesses are routed properly
and all connectors are plugged in.
43. Plug the 3-pin connector of the security system
wire harness into the 3-pin connector of the disarm
switch harness. Plug the 22-pin connector of the
security system wire harness into the control unit;
then reinstall the driver's dashboard lower cover.
44. Unplug the 4-pin connector from the right fuse box
and plug the 4-pin connector of the sub-harness
there.
46. Route the sub-harness along the vehicle harness.
Inside the glove box, locate the 2-pin connector
blue-taped to the vehicle harness, and remove the
blue tape to free the connector. Plug the 2-pin
connector of the sub-harness into the 2-pin
connector you just freed.
47. Secure the sub-harness to the vehicle with three
short wire ties.
45. Push the clip of the sub-harness 4-pin connector
into the hole in the right front inner lower pillar.
SUB-HARNESS
VEHICLE
4-PIN CONNECTOR
HOLE IN
INNER
LOWER
PILLAR
SUB-HARNESS
4-PIN CONNECTOR
SECURITY SYSTEM WIRE
HARNESS 3-PIN
CONNECTOR
DISARM SWITCH
3-PIN CONNECTOR
CONTROL UNIT
DRIVER'S
DASHBOARD
LOWER COVER
SECURITY SYSTEM WIRE HARNESS
22-PIN CONNECTOR
2-PIN
CONNECTOR
VEHICLE
HARNESS
SUB-
HARNESS
BLUE TAPE
(Remove.)
SHORT
WIRE TIES
BULKHEAD
CENTER STAY
COVER
48. Open the hood, and attach the cover on the
bulkhead center stay.
50. Reinstall all removed parts.
51. Reconnect the negative cable to the battery.
52. Enter the customer’s radio anti-theft code, if
applicable, and reset the radio station presets.
53. Reset the clock.
54. Check operation of the security system according
to the Owner’s Manual supplied.